HS0005KCU04H Renesas Electronics America, HS0005KCU04H Datasheet - Page 133

• Manufacturer Part Number: HS0005KCU04H
• Description: EMULATOR E10A-USB SUPERH RISC
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of HS0005KCU04H

• Contents: Emulation Module
• For Use With/related Products: SH7205, SH7265
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

[Trace Mode 2]: Decides whether or not operation continues after the trace buffer of the emulator
[AUD Mode]: Depending on the target device for debugging, an 8-bit AUD pin mode may be
[AUD trace Memory Size]: Set the size of the trace buffer memory for the emulator.
The specified contents are set by clicking on the [OK] button. If the [Cancel] button is clicked, the
dialog box is closed without the settings being made.
Also, settings other than those in the [Display Type] group box are common to the High-
performance Embedded Workshops for CPU0 and CPU1. Settings in the [Display Type] group
box are not common to the High-performance Embedded Workshops for CPU0 and CPU1.
[AUD trace display range]: Set the range for display in the trace window.
[Start pointer] Traced data are displayed from the value set here.
[End pointer]
[User Memory area]: Set the range for display in the trace window.
[Start]
are to be written.
[End address] Specify the last address of the region of memory where the results of
tracing are to be written.
[Trace Extend Mode]:
[Trace continue]: Continue to acquire the latest information by overwriting the oldest
[Trace stop]: Acquisition of trace information stops when the buffer is full.
[Trace data is PPC] Output values of the performance counter to the trace window.
selectable. Refer to the additional document, ″Supplementary Information on
Using the SHxxxx″ and the online help for the specifications of devices. This
mode is only valid when [AUD trace] is selected.
is full. This can only be used when [AUD trace] or [User Memory trace] is
selected.
Specify the first address of the region of memory where the results of tracing
Traced display are displayed up to the value set here.
[Realtime trace]: Some trace information will not be output.
[Non realtime trace]: The CPU is made to wait for the output of trace data.
This mode is only valid when [AUD trace] is selected.
trace information.
This mode is only valid when [User Memory trace] is selected.
This mode is only valid when [AUD trace] is selected.
Rev. 2.00 Nov. 19, 2009 Page 111 of 294
REJ10J1766-0200