HS0005KCU04H Renesas Electronics America, HS0005KCU04H Datasheet - Page 244

• Manufacturer Part Number: HS0005KCU04H
• Description: EMULATOR E10A-USB SUPERH RISC
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of HS0005KCU04H

• Contents: Emulation Module
• For Use With/related Products: SH7205, SH7265
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

7.10
Execute the program as described in the following:
•
Once program execution has started, ‘**RUNNING’ will be displayed on the status bar, along
with the address of the instruction being executed (PC value) and the value of the status register
(SR) in the case of products that support acquisition of the CPU state. The program will be
executed up to any breakpoint that was set in the High-performance Embedded Workshop for
CPU0. Since synchronized breaking has been selected (by the [All debuggers synchronized]
checkbox and the [Go] checkbox under [Synchronization options]) in the High-performance
Embedded Workshop for CPU1, execution by CPU0 will break at the same time. An arrow will be
displayed in the [S/W breakpoint] column of each High-performance Embedded Workshop to
indicate the positions where execution of the programs on the respective CPUs was suspended.
The messages [BREAKPOINT] and [SYNCHRONIZATION BREAK CPU#0] will appear in the
status bars of the High-performance Embedded Workshops for CPU0 and CPU1, respectively.
Notes: 1. When the source file is displayed after a break, a path of the source file may be
Rev. 2.00 Nov. 19, 2009 Page 222 of 294
REJ10J1766-0200
Since synchronized execution has been enabled in the [Synchronized debugging] dialog box
(by the [All debuggers synchronized] checkbox and the [Go] checkbox under
[Synchronization options]), execute the program by selecting [Go] from the [Debug] menu of
the High-performance Embedded Workshop for either core, and then selecting [Go] from the
[Debug] menu or selecting the [Go] button on the toolbar. For this tutorial, start execution by
selecting [Go] in the High-performance Embedded Workshop for CPU0.
2. If program execution is failed, select [Reset CPU] from the [Debug] menu, reset the
Executing the Program
inquired. The location of the source file is as follows:
<Drive where the OS has been installed>:
\WorkSpace\Tutorial\E10A-USB\MULTI-SH4AM\nCORES\CPU0\source
(n represents the number of CPU cores).
device, and restart the procedure from figure 7.8.
Figure 7.14 [Go] Button