HS0005KCU04H Renesas Electronics America, HS0005KCU04H Datasheet - Page 234

EMULATOR E10A-USB SUPERH RISC

HS0005KCU04H

Manufacturer Part Number
HS0005KCU04H
Description
EMULATOR E10A-USB SUPERH RISC
Manufacturer
Renesas Electronics America
Type
In Circuit Debuggerr
Datasheet

Specifications of HS0005KCU04H

Contents
Emulation Module
For Use With/related Products
SH7205, SH7265
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
7.4
The clocks which are used for data communications must be set up on the emulator before the
program is downloaded.
• AUD clock
• JTAG (H-UDI) clock (TCK)
The following is a description of the procedure used to set the clocks.
Rev. 2.00 Nov. 19, 2009 Page 212 of 294
REJ10J1766-0200
A clock used in acquiring AUD traces.
If its frequency is set too low, complete data may not be acquired during realtime tracing.
The frequency setting must also not exceed the supported device’s upper limit for the AUD
clock.
The AUD clock is only required for the AUD trace function.
A communication clock used except for acquiring AUD trace.
If its frequency is set too low, the speed of downloading will be lowered.
Set the frequency not to exceed the upper limit for the MPU’s guaranteed TCK range.
For details of the limitations on both clocks, refer to section 2.2.4, Notes on Using the JTAG
(H-UDI) Clock (TCK) and AUD Clock (AUDCK), in the additional document,
″Supplementary Information on Using the SHxxxx″.
Setting up the Emulator

Related parts for HS0005KCU04H