HS0005KCU04H Renesas Electronics America, HS0005KCU04H Datasheet - Page 180

• Manufacturer Part Number: HS0005KCU04H
• Description: EMULATOR E10A-USB SUPERH RISC
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of HS0005KCU04H

• Contents: Emulation Module
• For Use With/related Products: SH7205, SH7265
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Notes:
6.10
Execute the program as described in the following:
•
Once program execution has started, ‘**RUNNING’ will be displayed on the status bar. The
program will be executed up to any breakpoint that has been set in the High-performance
Embedded Workshop for CPU1. Since synchronized breaking is enabled ([All debuggers
synchronized], [Break/Program Halt] check box under [Synchronization options] selected), the
High-performance Embedded Workshops for CPU0 and CPU1 will break at the same time.
An arrow will be displayed in the [S/W breakpoint] column to indicate the position where the
program was suspended, and the message [BREAKPOINT] in the status bar.
Rev. 2.00 Nov. 19, 2009 Page 158 of 294
REJ10J1766-0200
Since the [Go] check box under [Synchronization options] in the [Synchronized debug] dialog
box is selected, execute the program by selecting [Go] from the [Debug] menu of the High-
performance Embedded Workshop for either CPU0 or CPU1, and then selecting [Go] from
the [Debug] menu or selecting the [Go] button on the toolbar of the High-performance
Embedded Workshop for CPU1.
1. When the source file is displayed after a break, a path of the source file may be
2. If program execution is failed, select [Reset CPU] from the [Debug] menu, reset the
Executing the Program
inquired. The location of the source file is as follows:
Display of the source file after a break may necessitate an enquiry regarding the path of
the source file. The location of the source file is as follows:
<Drive where the OS has been installed>:
\WorkSpace\Tutorial\E10A-USB\MULTI-SH2AD\xxxx\CPU1\source.
(**** represents the target device group).
device, and restart the procedure from figure 6.8.
Figure 6.14 [Go] Button