HS0005KCU04H Renesas Electronics America, HS0005KCU04H Datasheet - Page 307

• Manufacturer Part Number: HS0005KCU04H
• Description: EMULATOR E10A-USB SUPERH RISC
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of HS0005KCU04H

• Contents: Emulation Module
• For Use With/related Products: SH7205, SH7265
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

8. Load of Motorola S-type Files
9. Note on [Register] Window Operation During Program Execution
10. Break Functions
11. Number of BREAKPOINT and [Stop At] Settings in the [Run...] Menu
12. Note on RUN-TIME Display
13. Note on Displaying Timeout error
14. Note on Using the [Run Program] Dialog Box
This HEW does not support Motorola S-type files with only the CR code (H'0D) at the end of
each record. Load Motorola S-type files with the CR and LF codes (H'0D0A) at the end of
each record.
The register value cannot be changed in the [Register] window during program execution.
Even if the changed value is displayed, the register contents are not changed actually.
⎯ When the PC breakpoint is set in the internal flash memory area, the program is written to
⎯ BREAKPOINT cancellation
The maximum number of BREAKPOINTs and [Stop At] settings allowed in the [Run...] menu
is 255. Therefore, when 255 BREAKPOINTs are set, specification by [Stop At] in the [Run...]
menu becomes invalid. Use the BREAKPOINTs and [Stop At] in the [Run...] menu with 255
or less total settings.
The execution time of the user program displayed in the [Status] window is not a correct value
since the timer in the host computer has been used.
If Timeout error is displayed, the emulator cannot communicate with the target
microcomputer. Turn off the user system and connect the USB connector of the emulator
again by using the HEW.
When [Run...] is selected from the [Debug] menu to specify the stop address, there is the
following note:
⎯ When the breakpoint that has been set as Disable is specified as the stop address, note that
the internal flash memory each time the user program is executed. At this time, note that
the number of rewritable times will be decreased.
When the contents of the BREAKPOINT address is modified during user program
execution, the following message is displayed when the user program stops.
If the above message is displayed, cancel all BREAKPOINT settings with the [Delete All]
or [Disable] button in the [Eventpoint] window.
the breakpoint becomes Enable when the user program stops.
BREAKPOINT IS DELETED A=xxxxxxxx
Rev. 2.00 Nov. 19, 2009 Page 285 of 294
REJ10J1766-0200