101-0401 Rabbit Semiconductor, 101-0401 Datasheet - Page 23

• Manufacturer Part Number: 101-0401
• Description: KIT DEV RABBIT2000/TCP/IP
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 2000r
• Type: MPU Moduler

Specifications of 101-0401

• Rohs Status: RoHS non-compliant
• Contents: Rabbit 2000™ TCP/IP Development Board, Demo Board, Power Supply, Cable and Software
• Processor To Be Evaluated: Rabbit 2000
• Interface Type: RS-232, RS-485
• For Use With/related Products: RCM2000, RCM2010, RCM2020
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 101-0401; 316-1005; Q906133

3.5 Starting Dynamic C
Once the TCP/IP Development Board is set up and connected as described in Chapter 2
and Dynamic C has been installed, start Dynamic C by double-clicking on the Dynamic C
icon. Dynamic C defaults to using the serial port on your PC that you specified during
installation. If the port setting is correct, Dynamic C should detect the TCP/IP Develop-
ment Board and go through a sequence of steps to cold-boot the TCP/IP Development
Board and to compile the BIOS. (Some versions of Dynamic C will not do the initial BIOS
compile and load until the first time you compile a program.)
If you receive the message beginning “BIOS successfully compiled …” you are ready to
continue with the sample programs in the next chapter.
3.5.1 Communication Error Messages
If you receive the message
cable may be connected to the wrong COM port, a connection may be faulty, or the target
system may not be powered up. First, check both ends of the programming cable to ensure
that it is firmly plugged into the PC and the programming port.
If there are no faults with the hardware, select a different COM port within Dynamic C.
From the
then click OK. Press
still reports it is unable to locate the target system, repeat the above steps until you locate the
active COM port. You should receive a
once this step is completed successfully.
If Dynamic C appears to compile the BIOS successfully, but you then receive a communi-
cation error message when you compile and load a sample program, it is possible that your
PC cannot handle the higher program-loading baud rate. Try changing the maximum
download rate to a slower baud rate as follows.
• Locate the
If a program compiles and loads, but then loses target communication before you can
begin debugging, it is possible that your PC cannot handle the default debugging baud
rate. Try lowering the debugging baud rate as follows.
• Locate the
Getting Started
menu. Select a slower Max download baud rate.
menu. Choose a lower debug baud rate.
Options
Serial Options
Serial Options
menu, select
<Ctrl-Y>
No Rabbit Processor Detected
dialog in the Dynamic C
dialog in the Dynamic C
to force Dynamic C to recompile the BIOS. If Dynamic C
Communications
Bios compiled successfully
. Select another COM port from the list,
Options > Communications
Options > Communications
, the programming
message
19