101-0401 Rabbit Semiconductor, 101-0401 Datasheet - Page 44

• Manufacturer Part Number: 101-0401
• Description: KIT DEV RABBIT2000/TCP/IP
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 2000r
• Type: MPU Moduler

Specifications of 101-0401

• Rohs Status: RoHS non-compliant
• Contents: Rabbit 2000™ TCP/IP Development Board, Demo Board, Power Supply, Cable and Software
• Processor To Be Evaluated: Rabbit 2000
• Interface Type: RS-232, RS-485
• For Use With/related Products: RCM2000, RCM2010, RCM2020
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 101-0401; 316-1005; Q906133

4.8 Run the PINGME.C Demo
Connect the crossover cable from your computer’s Ethernet port to the TCP/IP Develop-
ment Board’s RJ-45 Ethernet connector. Open the
SAMPLES\TCPIP\ICMP
C. When the program starts running, the green
Board should be on to indicate an Ethernet connection is made. (Note: If the
does not light, you may not have a crossover cable, or if you are using a hub perhaps the
power is off on the hub.)
The next step is to ping the board from your PC. This can be done by bringing up the MS-
DOS window and running the ping program:
or by
and typing the command
Notice that the red
taking place indicating the transfer of data. The ping routine will ping the board four times
and write a summary message on the screen describing the operation.
40
Start > Run
ping 10.10.6.100
ping 10.10.6.100
ACT
light flashes on the TCP/IP Development Board while the ping is
folder, compile the program, and start it running under Dynamic
LNK
PINGME.C
light on the TCP/IP Development
sample program from the
TCP/IP Development Kit
LNK
light