DJLXT360LE.A2 S E001 Intel, DJLXT360LE.A2 S E001 Datasheet - Page 34

• Manufacturer Part Number: DJLXT360LE.A2 S E001
• Manufacturer: Intel

Specifications of DJLXT360LE.A2 S E001

• Number Of Transceivers: 1
• Operating Supply Voltage (typ): 5V
• Screening Level: Industrial
• Mounting: Surface Mount
• Operating Supply Voltage (min): 4.75V
• Operating Supply Voltage (max): 5.25V
• Operating Temperature (min): -40C
• Operating Temperature (max): 85C
• Lead Free Status / RoHS Status: Not Compliant

LXT360 — Integrated T1/E1 LH/SH Transceiver for DS1/DSX-1 or PRI Applications
34
Bit
Bit
Bit
0
1
2
3
4
5
6
7
0
1
2
3
0
1
2
3
4
5
6
7
Table 15. Performance Status Register Read Only, Address (A7-A0) = x010101x
Table 16. Equalizer Status Register Read Only, Address (A7-A0) = x010110x
Table 17. Control Register #4 Read/Write, Address (A7-A0) = x010111x
COL32CM
LOS2048
CODEV
NLOOP
ZEROV
DFMO
Name
QRSS
Name
LATN4
LATN5
LATN6
LATN7
BIST
Name
LOS
AIS
-
-
-
-
-
-
1 = Loss of Signal occurred.
0 = Loss of Signal did not occur.
1 = Network loopback active.
0 = Network loopback not active.
1 = Alarm Indicator Signal detected.
0 = Alarm Indicator Signal not detected.
1 = Quasi-Random Signal Source pattern detected.
0 = Quasi-Random Signal Source pattern not detected.
Reserved. Ignore.
1 = Driver Failure Monitor Open detected.
0 = Driver Failure Monitor Open not detected.
1 = Built-In Self Test passed.
0 = Built-In Self Test did not pass (or was not run).
Reserved. Ignore.
1 = Enable detection of HDB3 code violations at the BPV pin along with bipolar violations and Zero
Substitution Violations (if enabled).
0 = Disable detection of HDB3 code violations.
1 = Enable detection of HDB3 Zero Substitution Violations (four consecutive zeros). Note that Zero
Substitution Violations are reported at the BPV pin.
0 = Disable detection of HDB3 Zero Substitution Violations.
1 = Set LOS detection threshold to 2048 consecutive zeros.
0 = Set LOS detection threshold to 32 consecutive zeros (for E1 operation) or to 175 consecutive
zeros (for T1 operation).
1 = Set LOS clear condition criterion to receipt of 32 consecutive marks (E1 operation).
0 = Set LOS clear condition criterion to 12.5% mark density (E1 operation).
Reserved. Ignore.
Reserved. Ignore.
Reserved. Ignore.
Reserved. Ignore.
Receive Line Attenuation Indicators. Convert this binary output to a decimal number and multiply
by 2.9 dB to determine the approximate cable attenuation as seen by the receiver.
For example, if LATN7:4 = 1010
approximately 29 dB (2.9 dB x 10) of cable. This approximation assumes that a 3 V pulse was
transmitted.
BIN
(= 10
DEC
Function
Function
Function
), then the receiver is seeing a signal attenuated by
Datasheet