PSD835G2V-12U STMicroelectronics, PSD835G2V-12U Datasheet - Page 11

• Manufacturer Part Number: PSD835G2V-12U
• Manufacturer: STMicroelectronics

Specifications of PSD835G2V-12U

• Operating Temperature (max): 70C
• Operating Temperature (min): 0C
• Operating Temperature Classification: Commercial
• Package Type: TQFP
• Mounting: Surface Mount
• Pin Count: 80
• Lead Free Status / Rohs Status: Compliant

PSD835G2V
1
1.1
1.1.1
1.1.2
1.1.3
Description
The PSD family of memory systems for microcontrollers (MCUs) brings in-system-
programmability (ISP) to Flash memory and programmable logic. The result is a simple and
flexible solution for embedded designs. PSD devices combine many of the peripheral
functions found in MCU based applications.
The CPLD in the PSD devices features an optimized macrocell logic architecture. The PSD
macrocell was created to address the unique requirements of embedded system designs. It
allows direct connection between the system address/data bus, and the internal PSD
registers, to simplify communication between the MCU and other supporting devices.
The PSD family offers two methods to program the PSD Flash memory while the PSD is
soldered to the circuit board: In-System Programming (ISP) via JTAG, and In-Application
Programming (IAP).
In-system programming (ISP) via JTAG
An IEEE 1149.1 compliant JTAG In-system programming (ISP) interface is included on the
PSD enabling the entire device (Flash memories, PLD, configuration) to be rapidly
programmed while soldered to the circuit board. This requires no MCU participation, which
means the PSD can be programmed anytime, even when completely blank.
The innovative JTAG interface to Flash memories is an industry first, solving key problems
faced by designers and manufacturing houses, such as:
●
●
●
First time programming
How do I get firmware into the Flash memory the very first time? JTAG is the answer.
Program the blank PSD with no MCU involvement.
Inventory build-up of preprogrammed devices
How do I maintain an accurate count of pre-programmed Flash memory and PLD devices
based on customer demand? How many and what version? JTAG is the answer. Build your
hardware with blank PSDs soldered directly to the board and then custom program just
before they are shipped to the customer. No more labels on chips, and no more wasted
inventory.
Expensive sockets
How do I eliminate the need for expensive and unreliable sockets? JTAG is the answer.
Solder the PSD directly to the circuit board. Program first time and subsequent times with
JTAG. No need to handle devices and bend the fragile leads.
First time programming
Inventory buid-up of preprogrammed devices
Expendsive sockets
Doc ID 10585 Rev 3
Description
11/120