PEF82912FV14XP Lantiq, PEF82912FV14XP Datasheet - Page 86

• Manufacturer Part Number: PEF82912FV14XP
• Manufacturer: Lantiq

Specifications of PEF82912FV14XP

• Number Of Line Interfaces: 1
• Control Interface: HDLC
• Lead Free Status / Rohs Status: Supplier Unconfirmed

Transparent mode with ’On Change bit’ active
– Acknowledgment: There is no automatic acknowledgement in transparent mode.
– Latching: No latching is performed due to no execution.
– Reporting: This mode is almost identical to the Transparent Mode 6 ms. But a report
– Execution: No automatic execution in transparent modes. The appropriate actions
Transparent mode with TLL active
– Acknowledgement: There is no automatic acknowledgment in transparent mode.
– Latching: No latching is performed due to no execution.
– Reporting: This mode is almost identical to the Transparent Mode 6 ms. But a report
– Execution: No automatic execution in transparent modes. The appropriate actions
2.4.3.4
General
In the following examples some letters like A,B,C are used to symbolize EOC command.
There are also particular EOC commands mentioned which indicate special system
behavior (e.g. UTC, H). The examples are shown in tables.
Data Sheet
For details see above.
to the µC by an interrupt takes place only, if a change in the EOC message has been
detected.
can be programmed by the µC.
For details see above.
to the µC by an interrupt takes place only, if the new EOC command has been
detected in at least three consecutive EOC messages.
can be programmed by the µC.
Examples for different EOC modes
72
Functional Description
PEF 82912/82913
2001-03-30