pnx1700 NXP Semiconductors, pnx1700 Datasheet - Page 142

• Manufacturer Part Number: pnx1700
• Description: Connected Media Processor
• Manufacturer: NXP Semiconductors

1. Introduction
2. Functional Description
The Reset module initiates life for the PNX17xx Series system since it generates all
reset signals required for a correct initialization of the entire system (may include
board devices).
These resets signals are triggered by hardware (one type) or by software (three
types):
RST_CAUSE MMIO register holds the cause of the previous reset which allows the
software to know what happened before.
The Reset module generates three different reset signals to fully initialize a PNX17xx
Series system:
Remark: The JTAG state machine can also be reset through the JTAG pins.
•
•
•
•
•
•
•
Chapter 4: Reset
PNX17xx Series Data Book – Volume 1 of 1
Rev. 1 — 17 March 2006
It sends reset signals to all DCS bus modules and the TM5250 CPU.
It sends a reset signal on the SYS_RST_OUT_N pin that can be used by external
board devices. This signal is then de-asserted by software.
Hardware external reset input to the PNX17xx Series through the pins,
POR_IN_N or RESET_IN_N.
Software assert and release of the SYS_RST_OUT_N reset pin through a write
to an MMIO register write.
Software programmable watchdog timer which asserts the same reset signals as
the hardware reset induced by the assertion of RESET_IN_N pin when a time-out
is reached.
Software PNX17xx Series system reset which asserts the same reset signals as
the hardware reset induced by the assertion of RESET_IN_N pin.
jtag_rst_n. This signal is used internally to reset the JTAG state machine. The
signal is only asserted if the POR_IN_N pin is asserted. Therefore the only mean
to reset the JTAG state machine of PNX17xx Series is by asserting the
POR_IN_N
pin.Figure 1
Preliminary data sheet