ATA6617-P3QW Atmel, ATA6617-P3QW Datasheet - Page 8

• Manufacturer Part Number: ATA6617-P3QW
• Description: MCU W/LIN TX/5V REG/WTCDG 38VQFN
• Manufacturer: Atmel
• Series: AVR® ATA66 LIN-SBCr

Specifications of ATA6617-P3QW

• Core Processor: AVR
• Core Size: 8-Bit
• Speed: 16MHz
• Connectivity: I²C, LIN, SPI, UART/USART, USI
• Peripherals: Brown-out Detect/Reset, POR, PWM, Temp Sensor, WDT
• Number Of I /o: 16
• Program Memory Size: 16KB (16K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 512 x 8
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 11x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 38-VQFN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

3.3.14
3.3.15
3.3.16
3.3.17
3.3.18
3.3.19
8
Atmel ATA6616/ATA6617
KL_15 Pin
INH Output Pin
Reset Output Pin (NRES)
WD_OSC Output Pin
NTRIG Input Pin
Wake-up Events from Sleep or Silent Mode
The KL_15 pin is a high-voltage input used to wake up the device from Sleep or Silent Mode.
It is an edge-sensitive pin (low-to-high transition). It is usually connected to ignition to generate
a local wake-up in the application when the ignition is switched on. Although KL_15 pin is at
high voltage (V
KL_15 pin directly to GND if you do not need it. A debounce timer with a typical Tdb
160µs is implemented.
The input voltage threshold can be adjusted by varying the external resistor due to the input
current I
ceramic capacitor of 100nF are recommended. With this RC combination you can increase the
wake-up time Tw
You can also increase the wake-up time using external capacitors with higher values.
The INH Output pin is used to switch an external voltage regulator on during Normal or
Fail-safe Mode. The INH pin is switched off in Sleep or Silent Mode. It is possible to switch off
the external 1k master resistor via the INH pin for master node applications. The INH pin is
switched off during VCC undervoltage reset.
The Reset Output pin, an open-drain output, switches to low during V
watchdog failure.
The WD_OSC Output pin provides a typical voltage of 1.2V, which supplies an external resis-
tor with values between 34k and 120k to adjust the watchdog oscillator time.
The NTRIG Input pin is the trigger input for the window watchdog. A pull-up resistor is imple-
mented. A negative edge triggers the watchdog. The trigger signal (low) must exceed a
minimum time t
• LIN-bus
• WAKE pin
• EN pin
• KL_15
KL_15
. To protect this pin against voltage transients, a serial resistor of 47 k and a
trigmin
Batt
KL_15
), it is possible to switch the IC into Sleep or Silent Mode. Connect the
to generate a watchdog trigger.
and, therefore, the sensitivity against transients on the ignition Kl.15.
CC
undervoltage or a
9132D–AUTO–12/10
Kl_15
of