UPD78F0552MA-FAA-AX Renesas Electronics America, UPD78F0552MA-FAA-AX Datasheet - Page 261

• Manufacturer Part Number: UPD78F0552MA-FAA-AX
• Description: MCU 8BIT 16-SSOP
• Manufacturer: Renesas Electronics America
• Series: 78K0/Kx2-Lr

Specifications of UPD78F0552MA-FAA-AX

• Core Processor: 78K/0
• Core Size: 8-Bit
• Speed: 10MHz
• Connectivity: I²C, LIN, UART/USART
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 9
• Program Memory Size: 16KB (16K x 8)
• Program Memory Type: FLASH
• Ram Size: 768 x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

78K0/Kx2-L
R01UH0028EJ0400 Rev.4.00
Sep 27, 2010
Capture
Operation
Capture operation of
CR000
Capture operation of
CR010
Note The capture operation of CR010 is not affected by the setting of the CRC001 bit.
Caution To capture the count value of the TM00 register to the CR000 register by using the phase reverse to
Remark CRC001: Refer to 6.3 (2) Capture/compare control register 00 (CRC00).
External Input
that input to the TI000 pin, the interrupt request signal (INTTM000) is not generated after the value
has been captured. If the valid edge is detected on the TI010 pin during this operation, the capture
operation is not performed but the INTTM000 signal is generated as an external interrupt signal. To
not use the external interrupt, mask the INTTM000 signal.
ES110, ES100, ES010, ES000: Refer to 6.3 (4) Prescaler mode register 00 (PRM00).
Signal
CRC001 = 1
TI000 pin input
(reverse phase)
Interrupt signal
TI000 pin input
Interrupt signal
TI000 Pin Input
Table 6-2. Capture Operation of CR000 and CR010
Note
Set values of ES010 and
ES000
Position of edge to be
captured
01: Rising
00: Falling
11: Both edges
(cannot be captured)
INTTM000 signal is not
generated even if value
is captured.
Set values of ES010 and
ES000
Position of edge to be
captured
01: Rising
00: Falling
11: Both edges
INTTM010 signal is
generated each time
value is captured.
CHAPTER 6 16-BIT TIMER/EVENT COUNTER 00
CRC001 bit = 0
TI010 pin input
Interrupt signal
TI010 Pin Input
Set values of ES110 and
ES100
Position of edge to be
captured
01: Rising
00: Falling
11: Both edges
INTTM000 signal is
generated each time
value is captured.
247