MC68HC908AB32CFU Freescale Semiconductor, MC68HC908AB32CFU Datasheet - Page 124

• Manufacturer Part Number: MC68HC908AB32CFU
• Description: IC MCU 8MHZ 32K FLASH 64-QFP
• Manufacturer: Freescale Semiconductor
• Series: HC08r

Specifications of MC68HC908AB32CFU

• Core Processor: HC08
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: SCI, SPI
• Peripherals: POR, PWM
• Number Of I /o: 51
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 512 x 8
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 64-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

System Integration Module (SIM)
8.7 Low-Power Modes
8.7.1 Wait Mode
Technical Data
124
Executing the STOP or WAIT instruction puts the MCU in a low-power-
consumption mode for standby situations. The SIM holds the CPU in a
non-clocked state. The operation of each of these modes is described
below. Both STOP and WAIT clear the interrupt mask (I) in the condition
code register, allowing interrupts to occur.
In wait mode, the CPU clocks are inactive while the peripheral clocks
continue to run.
A module that is active during wait mode can wake up the CPU with an
interrupt if the interrupt is enabled. Stacking for the interrupt begins one
cycle after the WAIT instruction during which the interrupt occurred. In
wait mode, the CPU clocks are inactive. Refer to the wait mode
subsection of each module to see if the module is active or inactive in
wait mode. Some modules can be programmed to be active in wait
mode.
wait mode can also be exited by a reset or break. A break interrupt
during wait mode sets the SIM break STOP/WAIT bit, SBSW, in the SIM
break status register (SBSR). If the COP disable bit, COPD, in the
configuration register 1 (CONFIG1) is 0, then the computer operating
properly (COP) module is enabled and remains active in wait mode.
Figure 8-13
R/W
IDB
IAB
NOTE: Previous data can be operand data or the WAIT opcode, depending on the
System Integration Module (SIM)
last instruction.
WAIT ADDR
and
Figure 8-12. Wait Mode Entry Timing
Figure 8-12
PREVIOUS DATA
Figure 8-14
WAIT ADDR + 1
shows the timing for wait mode entry.
show the timing for wait recovery.
NEXT OPCODE
SAME
MC68HC908AB32
SAME
Freescale Semiconductor
SAME
SAME
—
Rev. 1.1