CS1W-CN625 Omron, CS1W-CN625 Datasheet - Page 128

• Manufacturer Part Number: CS1W-CN625
• Description: CBL,PROG
• Manufacturer: Omron

Specifications of CS1W-CN625

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Note
Note
Note
More than 3 network layer crossings (8 max.) are allowed with CS/CJ-series Units with
Version 2.0 or later ratings.
However, up to 8 network layer crossings are allowed only when the destination of the
FINS command is a CPU Unit. If the destination of the FINS command is not a CPU
Unit, the maximum number of network layer crossings is 3.
When the maximum number of network layer crossings is set to 3, it is possible to
combine Version 2.0 or later CS/CJ-series Units with other models.
If the maximum number of network layer crossings is set between 4 and 8, only
Version 2.0 or later CS/CJ-series Units can be used in the network. (Models other than
Version 2.0 and later CS/CJ-series Units cannot be included.) If other models are
used, a routing error (end code 0501 to 0504 Hex) may occur in a relay PLC or the
response may not be returned properly to the source node.
The connection between the computer and relay node can be checked with the Check
connection to Relay Node command.
The checking procedure is as follows:
1. Display the PLC Routing Table Window in Main View format and move the cursor
2. Right-click over the icon and select Check connection to Relay Node from the
3. The check results will be displayed in a Routing Table Dialog Box, like the one
If you click the Overview Tab, the following display will appear.
This example completes the procedure for creating a directly connected PLC's routing
tables.
over the relay node's icon, as shown above.
pop-up menu.
below.
Relay node address: 3
3-2-3 Setting the Gateway Counter
3-2 Setting the Routing Tables
3-19