CS1W-CN625 Omron, CS1W-CN625 Datasheet - Page 83

• Manufacturer Part Number: CS1W-CN625
• Description: CBL,PROG
• Manufacturer: Omron

Specifications of CS1W-CN625

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

2-3
2-3-1
2-3-2
2-3
Uploading the Serial Network Configuration Connected to a CPU Unit
Uploading Network Configurations and Check-
ing for Communications Unit Errors
Overview
Procedure
Uploading Network Configurations and Checking for Communications
CompoWay/F Networks
With the CX-Integrator, the actual network configuration including component
parameters can be uploaded from the target PLC and displayed in the Network
Configuration Window.
Note: The network that is uploaded will be automatically added to the Workspace Window.
After uploading the network, check the connection status of the nodes and check the
status of Communications Units (check for errors).
Right-click a Communications Unit or port below TargetDevice in the Online
Connection Information Window and select Connect from the pop-up menu.
Accessing the Communications Unit or port will be enabled and the icon to the left will
change to
displayed (Net(-) displayed), it will be necessary to select the desired network in the
Workspace Window, right-click, and select Connect. )
Then select Transfer [Network to PC].
Note: When uploading the network configuration of a target PLC through the relay PLC, select
Right-click a CPU Unit under TargetPLC in the Online Connection Information Window
and select Connect from the pop-up menu. The serial port will become accessible.
(If the network has been uploaded but a network address is not displayed (Net(-)
displayed), it will be necessary to select the desired network in the Workspace
Window, right-click, and select Connect. )
Right-click the CPU Unit again and then select Transfer [Network to PC].
Refer to ntlp:CheckReference 7-2 PLCs and Connected CompoWay/F Slaves for
details.
Computer running
CX-Integrator
Relay PLC
and right-click the desired target PLC on the network and select Connect to this PLC
from the pop-up menu to make that PLC the target PLC. Refer to 2-4 Switching the
Target PLC for details.
. (If the network has been uploaded but a network address is not
Upload
Network Configuration Window
CS/CJ Series PLC
Target PLC
Access must be enabled by executing Connect.
Example: Controller Link
2-3-1
Unit Errors
Overview
2-19