CS1W-CN625 Omron, CS1W-CN625 Datasheet - Page 23

• Manufacturer Part Number: CS1W-CN625
• Description: CBL,PROG
• Manufacturer: Omron

Specifications of CS1W-CN625

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

1-1-4
Accessible Networks
Accessible Serial Communications
Accessible Network
The network configuration of the target PLC (i.e., either the relay PLC or a PLC
connected to the relay PLC) can be uploaded and monitored for each of the following
networks.
Ethernet
Controller Link
SYSMAC LINK
DeviceNet
CompoWay/F
NT Link
communications
Network
Serial
Monitoring and editing parameters is possible for all CS/CJ-series PLCs
on the Ethernet network. Only monitoring the network configuration is
possible for CVM1/CV-series PLCs and computers with FinsGateway.
Monitoring and editing parameters is possible for all CS/CJ-series PLCs
on the Controller Link network. Only monitoring the network configuration
is possible for C200HX/HG/HE/HS PLCs, CVM1/CV-series PLCs, and
computers with FinsGateway.
Monitoring and editing parameters is possible for all CS/CJ-series PLCs
on the SYSMAC LINK network. Only monitoring the network configuration
is possible for C200HX/HG/HE/HS PLCs, CVM1/CV-series PLCs, and
computers with FinsGateway.
Monitoring and editing parameters is possible for all CS/CJ-series
DeviceNet Units. Only setting the DeviceNet Master Unit is possible for
C200H-series DeviceNet Master Unit and CVM1/CV-series DeviceNet
Master Units.
The serial communications mode of the serial port must be Serial
Gateway Mode or Protocol Macro Mode. (See note.)
Note: To use the built-in serial ports on CS/CJ-series CPU Units, unit
Monitoring and parameter editing is possible only for CompoWay/F slaves
for which CPS files have been installed on the computer running the
CX-Integrator.
(If the CompoWay/F slave is a Temperature Controller, however, only
monitoring the network configuration is possible. Parameters are edited
using the CX-Thermo.)
The serial communications mode of the serial port must be 1:N NT Link.
Monitoring is possible only for NS-series PTs with model numbers ending
in V1or later. (Monitoring is not possible for earlier NS-series PTs without
a model number suffix or for NT-series PTs.)
version 3.0 or later must be used. For Serial Communications
Boards and Serial Communications Units, unit version 1.2 or later
must be used.
Conditions
Conditions
1-1
1-1-4
The CX-Integrator
Accessible Network
1-5