MPC852TADS Freescale Semiconductor, MPC852TADS Datasheet - Page 30

• Manufacturer Part Number: MPC852TADS
• Description: Networking Modules & Development Tools ADS BOARD FOR 852
• Manufacturer: Freescale Semiconductor
• Type: Network Controller & Processorr

Specifications of MPC852TADS

• Memory Type: Flash, SDRAM
• Interface Type: RS-232, Ethernet, PCMCIA
• Operating Voltage: 1.8 V to 3.3 V
• Operating Temperature Range: 0 C to + 30 C
• Board Size: 233 mm x 150 mm
• Product: Modules
• For Use With/related Products: MPC852T
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

18
ADS. When the MPC is reset that way, all configuration and all data residing in volatile memories are lost. After
PORST signal is negated, the MPC re-acquires the power-on reset and hard-reset configuration data from the hard-
reset configuration source. (Flash / BCSR).
3•2•7
The 4 GND bridges on the MPC852TADS are intended to assist in general measurements and logic-analyzer connec-
tions.
3•2•8
The green ETH TX/RX LED indicates that the Ethernet port, Davicom DM9161E on SCC4, is transmitting or receiv-
ing data via the 10 Base-T port.
3•2•9
The red ETH FDX LED indicates that the Ethernet port, Davicom DM9161E on SCC4, is in Full Duplex operation
mode.
3•2•10
The yellow ETH Twisted Pair LINK LED indicates, that there is a good link integrity on the 10-Base-T port. LD3 is
off when the link integrity fails.
3•2•11
The green FAST ETH 100Mpbs LED indicates that the Fast Ethernet port, Davicom DM9161E on Port D is in 100
Mbps operation mode.
3•2•12
The green FAST ETH TX/RX LED indicates that the Fast Ethernet port, Davicom DM9161E on Port D, is transmit-
ting or receiving data via the 10/100 Base-T port.
3•2•13
The red FAST ETH FDX LED indicates that the Fast Ethernet port, Davicom DM9161E on Port D, is in Full Duplex
operation mode.
3•2•14
The yellow FAST ETH Twisted Pair LINK LED indicates, that there is a good link integrity on the 10/100-Base-T
port. LD7 is off when the link integrity fails.
GND Bridges
Ethernet 10Base-T. ETH TX/RX, LD1
Ethernet Full Duplex Indicator, LD2
Ethernet LINK Indicator, LD3
Fast Ethernet 100Mbps Indicator, LD4
Fast Ethernet 10/100Base-T. TX/RX, LD5
Fast Ethernet Full Duplex Indicator, LD6
Fast Ethernet LINK Indicator, LD7
Use only INSULATED GND clips when connecting to a GND
bridge. Failure to do so may result in permanent damage to the
MPC852TADS.
Freescale Semiconductor, Inc.
For More Information On This Product,
OPERATING INSTRUCTIONS
Go to: www.freescale.com
MPC852TADS - User’s Manual
WARNING
Release 1.0