DSPB56364AF100 Freescale Semiconductor, DSPB56364AF100 Datasheet - Page 17

• Manufacturer Part Number: DSPB56364AF100
• Description: IC DSP 24BIT AUD 100MHZ 100-LQFP
• Manufacturer: Freescale Semiconductor
• Series: Symphony™r
• Type: Audio Processorr

Specifications of DSPB56364AF100

• Interface: Host Interface, I²C, SAI, SPI
• Clock Rate: 100MHz
• Non-volatile Memory: ROM (24 kB)
• On-chip Ram: 11.25kB
• Voltage - I/o: 3.30V
• Voltage - Core: 3.30V
• Operating Temperature: -40°C ~ 105°C
• Mounting Type: Surface Mount
• Package / Case: 100-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

3
3.1
The DSP56364 is a high density CMOS device with Transistor-Transistor Logic (TTL) compatible inputs
and outputs. The DSP56364 specifications are preliminary and are from design simulations, and may not
be fully tested or guaranteed. Finalized specifications will be published after full characterization and
device qualifications are complete.
3.2
Freescale Semiconductor
Specifications
Introduction
Maximum Ratings
This device contains circuitry protecting against damage due to high static
voltage or electrical fields. However, normal precautions should be taken to
avoid exceeding maximum voltage ratings. Reliability of operation is
enhanced if unused inputs are pulled to an appropriate logic voltage level
(e.g., either GND or V
resistor is 10 kΩ.
In the calculation of timing requirements, adding a maximum value of one
specification to a minimum value of another specification does not yield a
reasonable sum. A maximum specification is calculated using a worst case
variation of process parameter values in one direction. The minimum
specification is calculated using the worst case for the same parameters in
the opposite direction. Therefore, a “maximum” value for a specification
will never occur in the same device that has a “minimum” value for another
specification; adding a maximum to a minimum represents a condition that
can never exist.
DSP56364 Technical Data, Rev. 4.1
CC
). The suggested value for a pull-up or pull-down
CAUTION
NOTE
3-1