DP83848TSQ/NOPB National Semiconductor, DP83848TSQ/NOPB Datasheet - Page 12

• Manufacturer Part Number: DP83848TSQ/NOPB
• Description: IC TXRX ETHERNET PHYTER 40-LLP
• Manufacturer: National Semiconductor
• Type: Transceiverr

Specifications of DP83848TSQ/NOPB

• Number Of Drivers/receivers: 1/1
• Protocol: Ethernet
• Voltage - Supply: 3 V ~ 3.6 V
• Mounting Type: Surface Mount
• Package / Case: 40-LLP
• Data Rate: 100Mbps
• Supply Voltage Range: 3V To 3.6V
• Logic Case Style: LLP
• No. Of Pins: 40
• Operating Temperature Range: -40°C To +85°C
• Msl: MSL 2 - 1 Year
• Filter Terminals: SMD
• Rohs Compliant: Yes
• Data Rate Max: 10Mbps
• Driver Case Style: LLP
• For Use With: DP83848T-MAU-EK - BOARD EVALUATION DP83848T
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: DP83848TSQTR

www.national.com
AN0 (LED_LINK)
MII_MODE (RX_DV)
LED_CFG (CRS/CRS_DV)
MDIX_EN (RX_ER)
Signal Name
S, O, PU
S, O, PD
S, O, PU
S, O, PU
Type
Pin #
22
32
33
34
This input pin controls the advertised operating mode of the
DP83848T according to the following table. The value on this pin
is set by connecting it to GND (0) or V
tors. This pin should NEVER be connected directly to GND or
VCC.
The value set at this input is latched into the DP83848T at Hard-
ware-Reset.
The float/pull-down status of this pin is latched into the Basic
Mode Control Register and the Auto_Negotiation Advertisement
Register during Hardware-Reset.
The default is 1 since this pin has an internal pull-up.
MII MODE SELECT: This strapping option determines the oper-
ating mode of the MAC Data Interface. Default operation (No pull-
up) will enable normal MII Mode of operation. Strapping
MII_MODE high will cause the device to be in RMII mode of oper-
ation. Since the pin includes an internal pull-down, the default val-
ue is 0.
The following table details the configuration:
LED CONFIGURATION: This strapping option determines the
mode of operation of the LED pins. Default is Mode 1. Mode 1 and
Mode 2 can be controlled via the strap option. All modes are con-
figurable via register access.
SeeTable 3 for LED Mode Selection.
MDIX ENABLE: Default is to enable MDIX. This strapping option
disables Auto-MDIX. An external pull-down will disable Auto-
MDIX mode.
12
AN0
MII_MODE
0
1
0
1
10BASE-T Half-Duplex
100BASE-TX, Half-Duplex
10BASE-T, Half/Full-Duplex
100BASE-TX, Half/Full-Duplex
Description
Advertised Mode
MII Mode
RMII Mode
MAC Interface Mode
CC
(1) through 2.2 k resis-