FQM1-TER01 Omron, FQM1-TER01 Datasheet - Page 434

• Manufacturer Part Number: FQM1-TER01
• Description: 5M 4COND 22AWG TPE ST MALE M12
• Manufacturer: Omron

Specifications of FQM1-TER01

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: FQM1TER01

Note A default value of 100 s is allocated in Motion Control Modules for event servicing with the Coordinator
Note
Read DM at Startup Setting (Motion Control Modules)
Part of the DM Area in Motion Control Modules can be saved to flash memory. This setting specifies whether or
not to automatically retrieve the saved data when the power is turned ON.
If there isn’t valid data in flash memory to retrieve, the data won’t be retrieved and the corresponding DM Area
words will be cleared to zeroes. In this case, the Saved DM Data Invalid Flag (A751.11) can be read to check
whether or not the data was retrieved.
System Setup, Auxiliary Area Allocations, and Built-in I/O Allocations
The following table shows a breakdown of the peripheral servicing time.
Module
The default value for each servicing process is 6.25% of the last cycle’s cycle time. In general, it is rec-
ommended that the default value be used. Set a uniform servicing time only when peripheral servicing is
being delayed because each service process is being spread over several cycles.
Event service time for
Motion Control Modules
Event service time for
peripheral port
Event service time for
RS-232C port
Event service time for
RS-422A port
Cycle
time
(1) When the peripheral servicing time is set to a time longer than the default value, the cycle time will
(2) The fixed peripheral servicing time setting cannot be changed while the Module is in RUN mode or
Peripheral servicing time
Exchange data with Modules when necessary
Exchange data with peripheral port
Exchange data with serial communications ports
also be longer.
MONITOR mode.
Peripheral servicing
Common processes
Program execution
(Tasks executed)
Cyclic refreshing
I/O refreshing
Initialization
Power ON
6.25% of the previous
cycle’s cycle time
Same as above.
Same as above.
Same as above.
Default value
Uniform servicing time in ms:
0.0 to 25.5 ms (unit: 0.1 ms)
Setting range
Appendix C
407