PEB 20571 F V3.1 Infineon Technologies, PEB 20571 F V3.1 Datasheet - Page 186

• Manufacturer Part Number: PEB 20571 F V3.1
• Description: IC LINE CARD CTRLR DSP TQFP-100
• Manufacturer: Infineon Technologies

Specifications of PEB 20571 F V3.1

• Function: PBX Controller with DSP
• Interface: ISDN
• Voltage - Supply: 3.13 V ~ 3.47 V
• Current - Supply: 272.6mA
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 100-LFQFP
• Includes: Layer-1 Control, Signaling Control, Signal Processing, Voice Channel Handling
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Power (watts): -
• Number Of Circuits: -
• Other names: PEB20571FV3.1X; PEB20571FV31XP; SP000007539

MOSEL(1:0)
MODE(2:0)
MF_EN
OWIN(2:0)
Data Sheet
1 =
Interface Mode Selection (S/T, U
00 =
01 =
10 =
11 =
Mode Configuration (S/T, U
001 =
011 =
111 =
Multiframe Enable (S/T)
0 =
1 =
Oversampling Window Size (S/T, U
Specifies the width of the oversampling window in bit samples. The
window is centered about the middle of the bit. For example, a size of
16 means that, upon detection of (16/2) = 8 times logical ’1’, the
received bit is detected as ’1’. The window size is programmed in steps
of two as shown below:
000 =
001 =
010 =
DELIC read request of the TICCMR register which was sent to
the VIP. It includes initialization and configuration commands
and the channel addresses. The VIP returns these values
(instead of sending the actual VIP status information) within
the IOM-2000 STAT_n_m bit stream. The values are available
in the next frame (after next FSC) in DELIC TICSTR register.
Note: To avoid blocking, the DELIC must not issue this bit
Channel programmed to S/T mode
Channel programmed to U
reserved
reserved
Channel programmed to LT-T mode
Note: IOM-2000 cha. 0 and 1 are restricted to the modes LT-S
Channel programmed to LT-S mode (point-to-point or
extended passive bus configuration) or U
Channel programmed to LT-S mode (short passive bus mode)
Note: All other states are reserved. The reset value is 011, e.g.
Multiframes are disabled
Multiframes are enabled
2
4
6
during normal operation.
and U
programmed to the value 001 for these channels. Also
see
the default mode of VIP is LT-S
Section 3.2.4.2
PN
. This means that MODE(2..0) must not be
169
PN
)
PN
PN
)
on
PN
)
mode
page
58.
Register Description
PN
mode
PEB 20570
PEB 20571
2003-07-31