MSC8102D Motorola / Freescale Semiconductor, MSC8102D Datasheet - Page 27

no-image

MSC8102D

Manufacturer Part Number
MSC8102D
Description
Quad Core 16-Bit Digital Signal Processor
Manufacturer
Motorola / Freescale Semiconductor
Datasheet
Signal Name
GPIO20
TDM1RDAT
GPIO21
TDM0TSYN
GPIO22
TDM0TCLK
DONE2
DRACK2
GPIO23
TDM0TDAT
IRQ13
Output
Output
Output
Output
Output
Output
Output
Output
Output
Type
Input/
Input/
Input/
Input/
Input/
Input/
Input/
Input/
Table 1-7. GPIO, TDM, UART, and Timer Signals (Continued)
Input
Input
General-Purpose Input Output 20
One of 32 GPIO pins used as GPIO or as one of two dedicated inputs or one of two
dedicated outputs. For details, refer to the MSC8102 Reference Manual GPIO programing
model.
TDM1 Serial Receiver Data
The receive data signal for TDM 1. As an input, this can be the DATA_A data signal for
TDM 1. For configuration details, refer to the MSC8102 Reference Manual chapter
describing TDM operation.
General-Purpose Input Output 21
One of 32 GPIO pins used as GPIO or as one of two dedicated inputs or one of two
dedicated outputs. For details, refer to the MSC8102 Reference Manual GPIO programing
model.
TDM0 Transmit frame Sync
Transmit Frame Sync for TDM 0.
General-Purpose Input Output 22
One of 32 GPIO pins used as GPIO or as one of two dedicated inputs or one of two
dedicated outputs.For details, refer to the MSC8102 Reference Manual GPIO programing
model.
TDM 0 Transmit Clock
Transmit Clock for TDM 0.
DMA Done 2
Signifies that the channel must be terminated. If the DMA generates DONE, the channel
handling this peripheral is inactive. As an input to the DMA, DONE closes the channel
much like a normal channel closing.
Note:
DMA Data Request Acknowledge 2
Asserted by the DMA controller to indicate that the DMA controller has sampled the
peripheral request.
General-Purpose Input Output 23
One of 32 GPIO pins used as GPIO or as one of two dedicated inputs or one of two
dedicated outputs. For details, refer to the MSC8102 Reference Manual GPIO programing
model.
TDM0 Serial Transmitter Data
The transmit data signal for TDM 0. As an output, this can be the DATA_D data signal for
TDM 0. For configuration details, refer to the MSC8102 Reference Manual chapter
describing TDM operation.
Interrupt Request 13
One of fifteen external lines that can request a service routine, via the internal interrupt
controller, from the SC140 core.
See the MSC8102 Reference Manual chapters on DMA and GPIO for
information on configuring the DRACK or DONE mode and pin direction.
Description
GPIO, TDM, UART, and Timer Signals
1-19

Related parts for MSC8102D