AN1154 STMicroelectronics, AN1154 Datasheet - Page 38

• Manufacturer Part Number: AN1154
• Description: 8031-PSD DESIGN TUTORIAL
• Manufacturer: STMicroelectronics

AN1154 - APPLICATION NOTE
Figure 36. Explorer
Signals can be added to the Data Analyzer window using the Explorer by holding the “CTRL” button down,
and clicking on all the signals that you want to add to the Data Analyzer window. Once you have chosen
all the desired signals, right-click on one of the signals, and select Add Signals to Analyzer. Next, click
anywhere in the Data Analyzer window, and the signals you added will appear at the bottom of the window,
as shown in Figure 37.
Figure 37. Adding Signals to the Analyzer
For more information on the Explorer or Data Analyzer, please see the on-line help, and the PSDsilosIII
User Manual . Also, please refer to this manual for information on how to us the PSDsilosIII Watch Window,
which is beyond the scope of this tutorial.
Programming the M88 FLASH+PSD
The PSD Programmer is the programming interface to the ST MagicProIII
programmers. It enables downloading any PSD .obj file; and displays the Flash and EEPROM locations,
the PLD fuse-map, and the configuration bits (ACR). You can also perform the following operations from
the Functions menu:
– Blank Test: to check to see if the device is blank.
– Upload: to upload the contents of the device that were programmed to the buffer.
– Program: to program the device with the .obj file.
– Verify: to verify the programmed device against the .obj file in the buffer.
– Erase: to erase the device completely.
38/83
®
, PSDpro, and FlashLink
AI03173
AI03174