SPC5561MZQ132 Freescale Semiconductor / Motorola, SPC5561MZQ132 Datasheet - Page 48

• Manufacturer Part Number: SPC5561MZQ132
• Description: Power Architecture TM 32-bit MCU for Automotive
• Manufacturer: Freescale Semiconductor / Motorola

Revision History for the MPC5561 Data Sheet
The following table describes the changes made to information in tables and figures:
48
Section 3.7.1, “Input Value of Pins During POR Dependent on
Section 3.7.3, “Power-Down Sequence (VRC33
Section 3.13.6, “eTPU
Figure 1
Table 1
Location
Location
Orderable Part Numbers:
MPC5500 Family Part Numbers:
Added the following text directly before this section and after
Power-on Sequence:
‘The values in
up.
Before exiting the internal POR state, the voltage on the pins goes to high-impedance until POR negates. When the
internal POR negates, the functional state of the signal during reset applies and the weak pull devices (up or down)
are enabled as defined in the device Reference Manual. If V
the weak-pull devices can pull the signals to V
To avoid this condition, minimize the ramp time of the V
enable the external circuitry connected to the device outputs.’
Deleted entire section, including table and figure, because the MPC5561 does not have the eTPU module.
• Removed the 2 in the tape and reel designator in both the graphic and in the Tape and Reel Status text.
• Changed Qualification Status by adding ‘, general market flow’ to the M designator, and added an ‘S’ designator
• Changed footnote 1 to read: All devices are PPC5561, rather than MPC5561 or SPC5561, until product
• Increased the frequency values in the Maximum column by 2 ns.
• Changed the maximum operating frequency from 132 MHz to 135 MHz.
• Reordered rows to group devices by lead-free package types in descending frequency order, and leaded
• Footnote 2: added ‘ambient’ between ‘lowest’ and ‘operating’ and ‘highest’ and ‘operating.’
• Changed footnote 3 from ‘132 MHz allows only 128 MHz + 2% FM’ to ‘135 MHz allows for 132 MHz + 2% FM’.
with the description of ‘Fully spec. qualified, automotive flow.
qualifications are complete. Not all configurations are available in the PPC parts.
package types.
Table 27. Global and Text Changes Between Rev. 0.0 and Rev. 1.0 (continued)
Timing”
Table 7
Table 28. Table and Figure Changes Between Rev. 0.0 and 1.0
and
Table 8
MPC5561 Microcontroller Data Sheet, Rev. 2.0
do not include the effect of the weak pull devices on the output pins during power
Grounded)” Deleted the underscore in ORed_POR to become ORed POR.
Description of Changes
Description of Changes
DDE
VDD33:”
and V
DD
DDEH
supply to a time period less than the time required to
DD
Table 8
.
is too low to correctly propagate the logic signals,
Pin Status for Medium / Slow Pads During the
Freescale Semiconductor