SB2A-16A Qlogic Corporation, SB2A-16A Datasheet - Page 142

• Manufacturer Part Number: SB2A-16A
• Description: Development Tools, SANbox 16-port Switch
• Manufacturer: Qlogic Corporation

B – Command Line Interface
Set Setup Command
B-44
system
Prompts you in a line-by-line fashion to change system configuration settings.
Table B-14
new value or press the Enter key to accept the current value shown in brackets.
TrapCommunity
AuthFailureTrap
ProxyEnabled
Eth0NetworkDiscovery
Eth0NetworkAddress
Eth0NetworkMask
Eth0GatewayAddress
FCNetworkDiscovery
FCNetworkAddress
FCNetworkMask
FCGatewayAddress
Note:
Entry
describes the system configuration fields. For each parameter, enter a
Table B-13. SNMP Configuration Settings (Continued)
Entry
Changing the IP address will terminate all Ethernet management
sessions.
Table B-14. System Configuration Settings
Enables (True) or disables (False) the generation of traps in
response to trap authentication failures. The default is False.
Trap community password that authorizes an SNMP agent
to receive traps. This is a write-only field. The value on the
switch and the SNMP management server must be the
same. The default is “public”.
Enables (True) or disables (False) SNMP communication
with other switches in the fabric. The default is True.
Ethernet boot method: 1 - Static, 2 - Bootp, 3 -
DHCP, 4 - RARP. The default is 1 - Static.
Ethernet Internet Protocol (IP) address. The
default is 10.0.0.1.
Ethernet subnet mask address.
Ethernet IP address gateway.
Fibre Channel boot method: 1 - Static, 3 - DHCP.
The default is 1 - Static.
Fibre Channel Internet Protocol (IP) address for
the Ethernet port. The default is 0.0.0.0.
Fibre Channel subnet mask address. The default is
255.0.0.0.
Fibre Channel IP address gateway. The default is
10.0.0.254.
Description
Description
59021-06 A