SB2A-16A Qlogic Corporation, SB2A-16A Datasheet - Page 81

• Manufacturer Part Number: SB2A-16A
• Description: Development Tools, SANbox 16-port Switch
• Manufacturer: Qlogic Corporation

5.3.1
Maintenance – Exit
5.3.2
Maintenance – Image Unpack
59021-06 A
4.
5.
These options and their use are described in the following subsections.
This option closes the current login session. To log in again, enter the
maintenance mode account name and password (prom, prom). To return to
normal operation, power cycle the switch.
This option unpacks and installs new firmware when the current firmware has
become corrupt. Before using this option, you must load the new firmware image
file onto the switch. The steps to install new firmware using this option are as
follows:
1.
2.
Enter the maintenance mode account name and password (prom, prom),
and press the Enter key.
The maintenance menu displays several recovery options. To select a
switch recovery option, press the corresponding number (displayed in
option: field) on the keyboard and press the Enter key.
Place the switch in maintenance mode. Refer to the procedure for
maintenance mode in
Use FTP to load a new firmware image file onto the switch. Refer to
FTP and the CLI to Install Firmware” on page
firmware image file with the Image command.
Sanbox login: prom
Password:xxxx
[username@anteater:Itasca]% telnet 10.0.0.1
Trying 10.0.0.1...
Connected to 10.0.0.1.
Escape character is '^]'.
0)
1)
2)
3)
4)
5)
6)
7)
8)
9)
Option:
Exit
Image Unpack
Reset Network Config
Reset Password File
Copy Log Files
Remove Switch Config
Remake Filesystem
Reset Switch
Show Firmware Versions
Set Active Image
”Recovering a Switch” on page
4-19. Do not unpack the
5 – Diagnostics/Troubleshooting
5-12.
Recovering a Switch
”Using
5-13