SB2A-16A Qlogic Corporation, SB2A-16A Datasheet - Page 71

• Manufacturer Part Number: SB2A-16A
• Description: Development Tools, SANbox 16-port Switch
• Manufacturer: Qlogic Corporation

59021-06 A
2.
3.
4.
5.
6.
7.
Place the switch in maintenance mode. Press and hold the Maintenance
button, then power up the switch. Refer to
page 5-12
mode.
Establish a Telnet session with the switch using the default IP address
10.0.0.1.
Enter the account name (prom) and password (prom), and press the Enter
key.
The following menu is displayed. Enter "6" (Remake Filesystem) and press
the Enter key to recreate the configuration file.
When the recreate process is complete, select option 7 to reset the switch
and exit maintenance mode.
If a previously saved configuration file is available for the switch, do the
following to restore the configuration file.
a.
telnet 10.0.0.1
Sanbox2 login: prom
Password:xxxx
[username@host:Itasca]% telnet 10.0.0.1
Trying 10.0.0.1...
Connected to 10.0.0.1.
Escape character is '^]'.
0)
1)
2)
3)
4)
5)
6)
7)
8)
9)
Option: 6
Establish communications with the switch using the File Transfer
Protocol (FTP). Enter one of the following on the command line:
>ftp xxx.xxx.xxx.xxx
>ftp switchname
where xxx.xxx.xxx.xxx is the switch IP address and switchname is the
switch name associated with the IP address.
Exit
Image Unpack
Reset Network Config
Reset Password File
Copy Log Files
Remove Switch Config
Remake Filesystem
Reset Switch
Show Firmware Versions
Set Active Image
for more information about placing the switch in maintenance
or
”Recovering a Switch” on
5 – Diagnostics/Troubleshooting
POST Diagnostics
5-3