ppc440gr-3jb667cz Applied Micro Circuits Corporation (AMCC), ppc440gr-3jb667cz Datasheet - Page 76

• Manufacturer Part Number: ppc440gr-3jb667cz
• Description: Powerpc 440gr Embedded Processor
• Manufacturer: Applied Micro Circuits Corporation (AMCC)

DDR SDRAM I/O Specifications
The DDR SDRAM controller times its operation with internal PLB clock signals and generates MemClkOut0 from
the PLB clock. The PLB clock is an internal signal that cannot be directly observed. However MemClkOut0 is the
same frequency as the PLB clock signal and is in phase with the PLB clock signal.
Note:
In the following sections, the label MemClkOut0(0) refers to MemClkOut0 when it has not been phase-shifted, and
MemClkOut0(90) refers to MemClkOut0 when it has been phase-advanced 90°. Advancing MemClkOut0 by 90°
creates a 3/4 cycle setup time and 1/4 cycle hold time for the address and control signals in relation to
MemClkOut0(90). The rising edge of MemClkOut0(90) aligns with the first rising edge of the DQS signal.
The following DDR data is generated by means of simulation and includes logic, driver, package RLC, and lengths.
Values are calculated over best case and worst case processes with speed, temperature, and voltage as follows:
Best Case = Fast process, -40°C, +1.6V
Worst Case = Slow process, +85°C, +1.4V
Note:
conditions and maximum values are measured under worst case conditions.
The signals are terminated as indicated in the figure below for the DDR timing data in the following sections.
Figure 8. DDR SDRAM Simulation Signal Termination Model
76
Revision 1.19 – May 07, 2008
Preliminary Data Sheet
Note: This diagram illustrates the model of the DDR SDRAM interface used when generating simulation timing data.
MemClkOut0 can be advanced with respect to the PLB clock by means of the SDRAM0_CLKTR
In all the following DDR tables and timing diagrams, minimum values are measured under best case
programming register. In a typical system, users advance MemClkOut by 90°. This depends on the specific
application and requires a thorough understanding of the memory system in general (refer to the DDR
SDRAM controller chapter in the PowerPC 440GR User’s Manual).
It is not a recommended physical circuit design for this interface. An actual interface design will depend on many
factors, including the type of memory used and the board layout.
PPC440GR
Addr/Ctrl/Data/DQS
MemClkOut0
MemClkOut0
440GR – PPC440GR Embedded Processor
10pF
10pF
V
120Ω
TT
50Ω
30pF
= V
DD
/2
AMCC Proprietary