XRT83SL30ES Exar, XRT83SL30ES Datasheet - Page 34

• Manufacturer Part Number: XRT83SL30ES
• Description: Peripheral Drivers & Components - PCIs 1 CHT1/E1 LIUSH
• Manufacturer: Exar

Specifications of XRT83SL30ES

• Product Category: Peripheral Drivers & Components - PCIs
• Rohs: yes

XRT83SL30
SINGLE-CHANNEL T1/E1/J1 SH TRANSCEIVER WITH CLOCK RECOVERY AND JITTER ATTENUATOR
N+1 REDUNDANCY
N+1 redundancy has one backup card for N primary cards. Due to impedance mismatch and signal contention,
external relays are necessary when using this redundancy scheme. The advantage of relays is that they create
complete isolation between the primary cards and the backup card. This allows all transmitters and receivers
on the primary cards to be configured in internal impedance mode, providing one bill of materials for all
interface modes of operation. The transmit and receive sections of the XRT83SL30 are described separately.
TRANSMIT
For N+1 redundancy, the transmitters on all cards should be programmed for internal impedance mode
providing one bill of materials for T1/E1/J1. The transmitters on the backup card do not have to be tri-stated. To
swap the primary card, close the desired relays, and tri-state the transmitters on the failed primary card. A
0.68µF capacitor is used in series with TTIP for blocking DC bias. See
of the transmit section for an N+1 redundancy scheme.
N
OTE
: For simplification, the over voltage protection circuitry was omitted.
F
IGURE
Backplane Interface
15. S
IMPLIFIED
Backup Card
RxTSEL=0, External
RxTSEL=1, Internal
Primary Card
B
LOCK
D
IAGRAM
Rx
Rx
XRT83SL30
XRT83SL30
- R
31
ECEIVE
S
ECTION FOR
Line Interface Card
Figure 16
1:1
1:1
AND
for a simplified block diagram
T1/E1 Line
1+1 R
EDUNDANCY
REV. 1.0.1