MCIMX6S1AVM08ABR Freescale Semiconductor, MCIMX6S1AVM08ABR Datasheet - Page 143

• Manufacturer Part Number: MCIMX6S1AVM08ABR
• Description: Processors - Application Specialized i.MX6 Solo rev 1.1
• Manufacturer: Freescale Semiconductor
• Type: Multimedia Applicationsr

Specifications of MCIMX6S1AVM08ABR

• Rohs: yes
• Core: ARM Cortex A9
• Processor Series: i.MX6
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 800 MHz
• Data Ram Size: 16 KB
• Operating Supply Voltage: 1.175 V to 1.5 V
• Maximum Operating Temperature: + 125 C
• Mounting Style: SMD/SMT
• Package / Case: MAPBGA-624
• Interface Type: Parallel
• Memory Type: L1/L2 Cache, ROM, SRAM
• Minimum Operating Temperature: - 40 C
• Number Of Timers: 2

4.11.21.2 Receive Timing
1
4.11.22 USB PHY Parameters
This section describes the USB-OTG PHY and the USB Host port PHY parameters.
The USB PHY meets the electrical compliance requirements defined in the Universal Serial Bus Revision
2.0 OTG, USB Host with the amendments below (On-The-Go and Embedded Host Supplement to the USB
Revision 2.0 Specification is not applicable to Host port).
Freescale Semiconductor
Tstrobe
The timings in the table are guaranteed when:
—AC I/O voltage is between 0.9x to 1x of the I/O supply
—DDR_SEL configuration bits of the I/O are set to (10)b
Tsetup
Name
Tslew
Thold
•
•
•
•
Receive
DATA
STROBE
USB ENGINEERING CHANGE NOTICE
— Title: 5V Short Circuit Withstand Requirement Change
— Applies to: Universal Serial Bus Specification, Revision 2.0
Errata for USB Revision 2.0 April 27, 2000 as of 12/7/2000
USB ENGINEERING CHANGE NOTICE
— Title: Pull-up/Pull-down resistors
— Applies to: Universal Serial Bus Specification, Revision 2.0
USB ENGINEERING CHANGE NOTICE
— Title: Suspend Current Limit Changes
— Applies to: Universal Serial Bus Specification, Revision 2.0
strobe period
data hold time
data setup time
strobe/data rising/falling time
i.MX 6Solo/6DualLite Automotive and Infotainment Applications Processors, Rev. 1
Parameter
Figure 104. USB HSIC Receive Waveform
Table 97. USB HSIC Receive Parameters
4.166
Min
300
365
0.7
Tstrobe
4.167
Max
Thold
2
Tsetup
V/ns
Unit
ns
ps
ps
Measured at 50% point
Measured at 50% point
Averaged from 30% – 70% points
1
Comment
Electrical Characteristics
143