M5249C3 Freescale Semiconductor, M5249C3 Datasheet - Page 11

• Manufacturer Part Number: M5249C3
• Description: KIT EVAL FOR M5249 W/ETHERNET
• Manufacturer: Freescale Semiconductor
• Series: ColdFire®r
• Type: Microprocessorr

Specifications of M5249C3

• Contents: Module and Misc Hardware
• Processor To Be Evaluated: MCF5249
• Interface Type: RS-232, Ethernet
• For Use With/related Products: MCF5249
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

functional in its default mode, the Ethernet interface may be used by following the instructions provided
in
1.8.1
Unpack the computer board from its shipping box. Save the box for storing or reshipping. Refer to the
following list and verify that all the items are present. You should have received:
Once you have verified that all the items are present, remove the board from its protective jacket and
anti-static bag. Check the board for any visible damage. Ensure that there are no broken, damaged, or
missing parts. If you have not received all the items listed above or they are damaged, please contact Rapid
PCB immediately; for contact details please see the front of this manual.
1.8.2
The board, as shipped, is ready to be connected to a terminal and power supply without any need for
modification.
1.8.3
The board accepts three means of power supply connection, either P1, P2 or J11. Connector P1 is a 2.1mm
power jack, P2 a lever actuated connector and J11 is a PC disk drive type power connector. The board
accepts +7V to +14V DC at 1.0 Amp via either of the connectors.
1.8.4
The serial channel UART0 of the MCF5249 is used for serial communication and has a built in timer. This
timer is used by the dBUG ROM monitor to generate the baud rate used to communicate with a serial
Freescale Semiconductor
Appendix A, “Configuring dBUG for Network Downloads.”
•
•
•
•
•
•
•
M5249C3 Single Board Computer
M5249C3 User's Manual (this document)
One RS232 communication cable
One BDM (Background Debug Mode) “wiggler” cable
MCF5249UM ColdFire Integrated Microprocessor User Manual
ColdFire
A selection of Third Party Developer Tools and Literature
Unpacking
Preparing the Board for Use
Providing Power to the Board
Selecting Terminal Baud Rate
Figure 1-4
Avoid touching the MOS devices. Static discharge can and will damage
these devices.
®
Programmers Reference Manual
shows the position of the jumpers and connectors.
1
2
Table 1-1. Power Supply Connections on P2
Contact Number
M5249C3 User’s Manual, Rev. 1
NOTE
+7V to +14V DC
Ground
Voltage
M5249C3 Board
1-5