M5249C3 Freescale Semiconductor, M5249C3 Datasheet - Page 15

• Manufacturer Part Number: M5249C3
• Description: KIT EVAL FOR M5249 W/ETHERNET
• Manufacturer: Freescale Semiconductor
• Series: ColdFire®r
• Type: Microprocessorr

Specifications of M5249C3

• Contents: Module and Misc Hardware
• Processor To Be Evaluated: MCF5249
• Interface Type: RS-232, Ethernet
• For Use With/related Products: MCF5249
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Copyright 1995-2002 Motorola, Inc.
ColdFire MCF5249 EVS Firmware v2e.1a.xx (Build XXX on XXX
xx:xx:xx)
Enter 'help' for help.
dBUG>
The board is now ready for operation under the control of the debugger as described in
the Monitor/Debug Firmware.”
If you still are not receiving the proper response, your board may have been damaged. Contact Rapid PCB
for further instructions; please see the beginning of this manual for contact details.
1.10
Jumper settings are as follows:
Freescale Semiconductor
1. Make sure that the power supply is properly configured for polarity, voltage level and current
2. Check that the terminal and board are set for the same character format and baud.
3. Press the RESET button to insure that the board has been initialized properly.
capability (~1A) and is connected to the board.
M5249C3 Jumper Setup
JP1
JP2
JP3
JP4
JP5
JP6
JP7
JP8
JP9
JP10
‘*’ is used to indicate that default setting.
‘**’ is used to indicate mandatory setting for proper operation.
Jumper Setting
* 1-2
2-3
* 1-2
2-3
*1-2
2-3
*1-2
1-2
1-2
*1-2
2-3
*1-2
*1-2
*1-2
2-3
If you do not get the above response, perform the following checks:
M5249C3 User’s Manual, Rev. 1
Table 1-2. Jumper Settings
All Rights Reserved.
Audio DAC AK4360VF U1 De-emphasis on
Audio DAC AK4360VF U1 De-emphasis off
Audio DAC AK4360VF U1 Boost -high pass correction on
Audio DAC AK4360VF U1 Boost - high pass correction off
Audio DAC AK4360VF U1 Clock sample rate = 384fs
Audio DAC AK4360VF U1 Clock sample rate = 256fs
Audio DAC AK4360VF U1 Audio format I
Audio DAC AK4360VF U1 Audio format 16-bit LSB justified
Not connected - I2C channel 0 pull-up SDA0, MCF5249 U2
Not connected - I2C channel 0 pull-up SCL0, MCF5249 U2
BDM mode selected at power-on/reset (POR)
JTAG mode selected at power-on/reset (POR)
Current measurement for the CPU core +1.8V
Current measurement for the CPU I/O pads +3.3V
BDM connector (J2) I/O or Pad voltage +3.3V
NOTE
Function
XX 20XX
2
S 16/18/20 bit
Chapter 2, “Using
M5249C3 Board
1-9