tda5235 Infineon Technologies Corporation, tda5235 Datasheet - Page 29

no-image

tda5235

Manufacturer Part Number
tda5235
Description
Enhanced Sensitivity Double-configuration Receiver With Digital Baseband Processing
Manufacturer
Infineon Technologies Corporation
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
TDA5235
Manufacturer:
TI
Quantity:
2 400
Part Number:
TDA5235
Manufacturer:
INFINEON/英飞凌
Quantity:
20 000
Part Number:
TDA5235
0
Company:
Part Number:
TDA5235
Quantity:
4 800
Company:
Part Number:
TDA5235
Quantity:
138
Figure 11
The bandwidth (and thus settling time) of the loop is programmed by means of the
integrator gain coefficients K1 and K2 (x_AFCK1CFG and x_AFCK2CFG register).
K1 mainly determines the bandwidth. K2 influences the dynamics/damping (overshoot)
- smaller K2 means smaller overshoot, but slower dynamics. The bandwidth of the AFC
loop is approximately 1.3*K1.
To avoid residual FM, limiting the AFC BW to 1/20 ~ 1/40 of the bit rate is suggested,
therefore K1 must be set to approximately 1/50 ~ 1/100 of the bit rate. For most
applications K2 can be set equal to K1 (overshoot is then <25%).
When very fast settling is necessary K1 and K2 can be increased up to bit rate/10,
however, in this case approximately 1dB sensitivity loss is to be expected due to the AFC
counteracting the input FSK signal.
AFC limitation at Local Oscillator (LO) frequencies at multiples of reference frequency
(f_xtal). When AFC is activated and AFC drives the wanted LO frequency over the
integer limit of Sigma Delta (SD) modulator, the SD modulator stucks at frac=1.0 or
frac=0.0 due to saturation. So when AFC can change the integer value for the LO
(register x_PLLINTC1) within the frequency range LO-frequency +/- AFC-limit, a change
of the LO injection side or a smaller AFC-limit is recommended.
The frequency offset found by AFC (AFC loop filter output) can be readout via register
AFCOFFSET, when AFC is activated. The value is in signed representation and has a
frequency resolution of 2.68 kHz/digit. The output can be limited by the x_AFCLIMIT
register.
Data Sheet
AFC Demod out
AFC Loop Filter (I-PI Filtering and Mapping)
K1 = integrator1 gain
x_AFCK1CFG0/1
x16
K1
limit
hold
integrator 1
K2 = integrator 2 gain
x_AFCK2CFG0/1
K2
x4
29
hold
limit
integrator 2
x_AFCLIMIT
scaling &
SDPLL
limiting
Functional Description
x_AFCAGCD
Freeze* / Track
HOLD
Delay
V1.0, 2010-02-19
FreqOffset
TDA5235

Related parts for tda5235