MC908JB8ADWE Freescale Semiconductor, MC908JB8ADWE Datasheet - Page 104

• Manufacturer Part Number: MC908JB8ADWE
• Description: IC MCU 3MHZ 8K FLASH 28-SOIC
• Manufacturer: Freescale Semiconductor
• Series: HC08r

Specifications of MC908JB8ADWE

• Core Processor: HC08
• Core Size: 8-Bit
• Speed: 3MHz
• Connectivity: USB
• Peripherals: LVD, POR, PWM
• Number Of I /o: 21
• Program Memory Size: 8KB (8K x 8)
• Program Memory Type: FLASH
• Ram Size: 256 x 8
• Voltage - Supply (vcc/vdd): 4 V ~ 5.5 V
• Oscillator Type: Internal
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 28-SOIC (7.5mm Width)
• Processor Series: HC08JB
• Core: HC08
• Data Bus Width: 8 bit
• Data Ram Size: 256 B
• Interface Type: USB
• Maximum Clock Frequency: 3 MHz
• Number Of Programmable I/os: 37
• Number Of Timers: 2
• Operating Supply Voltage: 5.25 V
• Maximum Operating Temperature: + 70 C
• Mounting Style: SMD/SMT
• Development Tools By Supplier: FSICEBASE, DEMO908GZ60E, M68EML08GZE, KITUSBSPIDGLEVME, KITUSBSPIEVME, KIT33810EKEVME
• Minimum Operating Temperature: 0 C
• Controller Family/series: HC08
• No. Of I/o's: 21
• Ram Memory Size: 256Byte
• Cpu Speed: 8MHz
• No. Of Timers: 1
• Embedded Interface Type: SCI, SPI
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Data Converters: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

System Integration Module (SIM)
8.5.2 SIM Counter During Stop Mode Recovery
8.5.3 SIM Counter and Reset States
8.6 Exception Control
8.6.1 Interrupts
Technical Data
104
The SIM counter also is used for stop mode recovery. The STOP
instruction clears the SIM counter. After an interrupt, break, or reset, the
SIM senses the state of the short stop recovery bit, SSREC, in the
configuration register (CONFIG). If the SSREC bit is a logic 1, then the
stop recovery is reduced from the normal delay of 4096 OSCXCLK
cycles down to 2048 OSCXCLK cycles. This is ideal for applications
using canned oscillators that do not require long startup times from stop
mode. External crystal applications should use the full stop recovery
time, that is, with SSREC cleared in the configuration register (CONFIG).
External reset has no effect on the SIM counter. (See
for details.) The SIM counter is free-running after all reset states. (See
8.4.2 Active Resets from Internal Sources
internal reset recovery sequences.)
Normal, sequential program execution can be changed in three different
ways:
An interrupt temporarily changes the sequence of program execution to
respond to a particular event.
system interrupts.
•
•
•
Interrupts
– Maskable hardware CPU interrupts
– Non-maskable software interrupt instruction (SWI)
Reset
Break interrupts
System Integration Module (SIM)
MC68HC908JB8•MC68HC08JB8•MC68HC08JT8 — Rev. 2.3
Figure 8-8
flow charts the handling of
for counter control and
Freescale Semiconductor
8.7.2 Stop Mode