MC9S08LC36LH Freescale Semiconductor, MC9S08LC36LH Datasheet - Page 126

• Manufacturer Part Number: MC9S08LC36LH
• Description: IC MCU 36K FLASH 2K RAM 64-LQFP
• Manufacturer: Freescale Semiconductor
• Series: HCS08r

Specifications of MC9S08LC36LH

• Core Processor: HCS08
• Core Size: 8-Bit
• Speed: 40MHz
• Connectivity: I²C, SCI, SPI
• Peripherals: LCD, LVD, POR, PWM, WDT
• Number Of I /o: 18
• Program Memory Size: 36KB (36K x 8)
• Program Memory Type: FLASH
• Ram Size: 2.5K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 3.6 V
• Data Converters: A/D 2x12b
• Oscillator Type: External
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 64-LQFP
• Processor Series: S08LC
• Core: HCS08
• Data Bus Width: 8 bit
• Data Ram Size: 2.5 KB
• Interface Type: I2C/SCI/SPI1/SPI2
• Maximum Clock Frequency: 40 MHz
• Number Of Programmable I/os: 18
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• 3rd Party Development Tools: EWS08
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 2-ch x 12-bit
• For Use With: DEMO9S08LC60 - BOARD DEMO FOR 9S08LC60
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Chapter 9 Liquid Crystal Display Driver (S08LCDV1)
Blinking functionality remains active in wait or stop3 mode. If the MCU is in wait or stop3, the LCDRAM
registers cannot be changed. Stop3 provides the lowest power consumption state where the LCD module
is functional.
9.1.3
Figure 9-2
126
BUS
IP
Mode
Stop3
Wait
is a block diagram of the LCD module.
Block Diagram
LCD DIGITAL
Depending on the state of the LCDSTP3 bit, the LCD module can operate an LCD panel in stop3 mode.
If LCDSTP3 = 1, LCD module clock generation is turned off and the LCD module enters a power
conservation state.If LCDSTP3 = 0, the LCD module can operate an LCD panel in stop3, and the LCD
module continues to display the current LCD panel contents base on the LCDRAM registers.
If the LCD is enabled in stop3, the ICGERCLK must be selected as the clock source since the bus clock
is not available in stop3.
Depending on the configuration, the LCD module can operate an LCD panel in wait mode. If LCDWAI = 1,
the LCD module clock generation is turned off and the LCD module enters a power conservation state.If
LCDWAI = 0, the LCD module can operate an LCD panel in wait, and the LCD module continues to
display the current LCD panel contents base on the LCDRAM registers.
lcd_ipbus_interface
MC9S08LC60 Series Data Sheet: Technical Data, Rev. 4
Table 9-2. Modes of Operation (continued)
Figure 9-2. LCD Driver Block Diagram
CONTROL
LCD CHARGE PUMP
lcd_regs
lcd_control
CLOCK INPUT
lcd_clkgen
Operation
LCD RAM
CLOCK
BASE
lcd_vgen
V
V
V
LL1
LL2
LL3
Freescale Semiconductor
FP/BP DRIVER
LCD