D12312SVF20V Renesas Electronics America, D12312SVF20V Datasheet - Page 529

• Manufacturer Part Number: D12312SVF20V
• Description: IC H8S/2312S MCU ROMLESS 100QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of D12312SVF20V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: SCI, SmartCard
• Peripherals: POR, PWM, WDT
• Number Of I /o: 70
• Program Memory Type: ROMless
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-QFP
• For Use With: EDK2329 - DEV EVALUATION KIT H8S/2329
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

• Reception
Receive operation should be stopped (by clearing RE to 0) before making a module stop mode
or software standby mode transition. RSR, RDR, and SSR are reset. If a transition is made
without stopping operation, the data being received will be invalid.
To continue receiving without changing the reception mode after the relevant mode is cleared,
set RE to 1 before starting reception. To receive with a different receive mode, the procedure
must be started again from initialization.
Figure 12.26 shows a sample flowchart for mode transition during reception.
Read TEND flag in SSR
Figure 12.23 Sample Flowchart for Mode Transition during Transmission
<Start of transmission>
Transition to software
standby mode, etc.
standby mode, etc.
Exit from software
operating mode?
<Transmission>
Yes
Yes
Yes
transmitted?
Initialization
TEND = 1
Change
All data
TE = 0
No
No
No
[1]
[2]
[3]
TE = 1
Section 12 Serial Communication Interface (SCI)
[1] Data being transmitted is interrupted.
[2] If TIE and TEIE are set to 1, clear
[3] Includes module stop mode.
After exiting software standby mode,
etc., normal CPU transmission is
possible by setting TE to 1, reading
SSR, writing TDR, and clearing
TDRE to 0, but note that if the DTC
has been activated, the remaining
data in DTCRAM will be transmitted
when TE and TIE are set to 1.
them to 0 in the same way.
Rev.7.00 Feb. 14, 2007 page 495 of 1108
REJ09B0089-0700