HD64F3664BPV Renesas Electronics America, HD64F3664BPV Datasheet - Page 273

• Manufacturer Part Number: HD64F3664BPV
• Description: MCU 3/5V 32K,PB-FREE 42-DIP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300H Tinyr

Specifications of HD64F3664BPV

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 16MHz
• Connectivity: I²C, SCI
• Peripherals: PWM, WDT
• Number Of I /o: 29
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 42-DIP (0.600", 15.24mm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Bit
3
2
Bit Name
ACKE
BBSY
Initial
Value
0
0
R/W
R/W
R/W
Description
Acknowledge Bit Judgement Selection
0: The value of the acknowledge bit is ignored, and
1: If the acknowledge bit is 1, continuous transfer is
Bus Busy
In slave mode, reading the BBSY flag enables to
confirm whether the I
The BBSY flag is set to 0 when the SDA level changes
from high to low under the condition of SCl = high,
assuming that the start condition has been issued. The
BBSY flag is cleared to 0 when the SDA level changes
from low to high under the condition of SCl = high,
assuming that the start condition has been issued.
Writing to the BBSY flag in slave mode is disabled.
In master mode, the BBSY flag is used to issue start
and stop conditions. Write 1 to BBSY and 0 to SCP to
issue a start condition. Follow this procedure when also
re-transmitting a start condition. To issue a start/stop
condition, use the MOV instruction. The I
interface must be set in master transmit mode before
the issue of a start condition.
continuous transfer is performed. The value of the
received acknowledge bit is not indicated by the
ACKB bit, which is always 0.
interrupted.
Rev. 6.00 Mar. 24, 2006 Page 243 of 412
2
C bus is occupied or released.
Section 15 I
2
C Bus Interface (IIC)
REJ09B0142-0600
2
C bus