NRF9E5 NORDIC SEMICONDUCTOR, NRF9E5 Datasheet - Page 89

• Manufacturer Part Number: NRF9E5
• Description: TRX, 430-928MHZ, MCU/ADC/PWM, SMD
• Manufacturer: NORDIC SEMICONDUCTOR

Specifications of NRF9E5

• Receiving Current: 12.5mA
• Transmitting Current: 30mA
• Data Rate: 50Kbps
• Frequency Range: 430MHz To 928MHz
• Modulation Type: GFSK
• Rf Ic Case Style: QFN
• No. Of Pins: 32
• Supply Voltage Range: 1.9V To
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

PRODUCT SPECIFICATION
nRF9E5 Single Chip Transceiver with Embedded Microcontroller and ADC
For noise rejection, the serial port establishes the content of each received bit by a
majority decision of three consecutive samples in the middle of each bit time. This is
especially true for the start bit. If the falling edge on RXD is not verified by a majority
decision of three consecutive samples (low), then the serial port stops reception and
waits for another falling edge on RXD.
At the middle of the stop bit time, the serial port checks for the following conditions:
If the above conditions are met, the serial port then writes the received byte to the SBUF
register, loads the stop bit into RB8, and sets the RI bit. If the above conditions are not
met, the received data is lost, the SBUF register and RB8 bit are not loaded, and the RI
bit is not set. After the middle of the stop bit time, the serial port waits for another high-
to-low transition on the RXD pin.
Mode 1 operation is identical to that of the standard 8051 when Timers 1 and 2 use
CPU_clk/12 (the default).
18.9.3 Mode 2
Mode 2 provides asynchronous, full-duplex communication, using a total of eleven bits:
The data bits are transmitted and received LSB first. For transmission, the 9th bit is
determined by the value in TB8. To use the 9th bit as a parity bit, move the value of the
P bit (SFR PSW.0) to TB8.
The mode 2 baud rate is either CPU_clk/32 or CPU_clk/64, as determined by the SMOD
bit. The formula for the mode 2 baud rate is:
Mode 2 operation is identical to the standard 8051.
18.9.3.1 Mode 2 Transmit
Figure 30 illustrates the mode 2 transmit timing. Transmission begins after the first
rollover of the divide-by-16 counter following a software write to SBUF . The UART
shifts data out on the TXD pin in the following order: start bit, data bits (LSB first), 9th
bit, stop bit. The TI bit is set when the stop bit is placed on the TXD pin.
Main office: Nordic Semiconductor ASA - Vestre Rosten 81, N-7075 Tiller, Norway -Phone [phone] - Fax [phone]
Revision: 1.3
- RI = 0
- If SM2 = 1, the state of the stop bit is 1
- One start bit
- Eight data bits
- One programmable 9th bit
- One stop bit
(if SM2 = 0, the state of the stop bit does not matter)
Baud Rate =
Page 89 of 108
2
SMOD
64
clk
June 2006