CS1D-II102D Omron, CS1D-II102D Datasheet - Page 83

• Manufacturer Part Number: CS1D-II102D
• Description: CS1D Dual IO Interface Unit
• Manufacturer: Omron

Specifications of CS1D-II102D

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Duplex Unit
Communications Setting
Switch
48
PRPHL
COMM
A39512
RSV
Pin
Peripheral port
communications
(In place of pin 4
of the DIP
switches.)
RS-232C commu-
nications condi-
tions
(In place of pin 5
of the DIP
switches.)
User-customized
DIP switch pin
(In place of pin 6
of the DIP
switches.)
Contents
Note
Note If the Initial Switch is pressed immediately after the power supply is turned
ON
OFF
(default)
ON
OFF
(default)
ON
OFF
(default)
Dis-
abled
Initial Switch
Press the Initial Switch to toggle between Duplex Mode and Simplex Mode
after a CS1D CPU Unit has been replaced.
ON, it may not have any effect.
In place of pins 4, 5, and 6 of the DIP switches on the right and left CPU Units,
set the PRPHL and COMM pins and bit A39512 as shown in the following
table.
Turn OFF pins 4, 5, and 6 on both the right and left CPU Units.
1. The order of automatic detection looks for a Programming Console first
INIT.
ON
The Mode Setting
Switch is enabled
when this switch is
pressed.
SW
and then it will attempt to detect a peripheral bus connect at the following
speeds: 9,600 bps, 19,200 bps, 38,400 bps, and then 115,200 bps. If the
Programming Device is in a mode other than peripheral bus, or if it is set
Setting
According to the peripheral port baud
rate setting in the PLC Setup. (See
note 3.)
Connect a Programming Console or
CX-Programmer at the baud rate for
Programming Devices. (The commu-
nications conditions are automatically
detected.) (See note 1.)
Connect a CX-Programmer at the
baud rate for Programming Consoles.
(The baud rate is automatically
detected.) (See note 2.)
According to the RS-232C port com-
munications conditions settings in the
PLC Setup.
A39512 ON
A39512 OFF
Set to OFF.
COMM
A39512
PRPHL
RSV
Reflects the status
(Duplex/Simplex Mode) of the
Mode Setting Switch while the
power is ON.
Setting
Contents
Leave OFF when peripheral port is to
be used by a Programming Console
or CX-Programmer (with peripheral
bus setting).
Turn ON when peripheral port is to be
used by other than a Programming
Console or CX-Programmer (periph-
eral bus).
Leave OFF when RS-232C port is to
be used by other than a CX-Program-
mer (peripheral bus), such as a PT or
host computer.
Turn ON when RS-232C port is to be
used by a CX-Programmer (periph-
eral bus).
The status of this DIP switch pin is
reflected in the User DIP Switch Pin
Flag (A39512) in the Auxiliary Area.
Press to return to Duplex
Mode after a CS1D CPU Unit
has been replaced.
If there is no change in the
Mode Setting Switch, then the
mode (Duplex/Simplex) will
not be changed even if the Ini-
tial Switch is pressed.
Applications
Application
Section 2-3