EP3C5F256C8N Altera, EP3C5F256C8N Datasheet - Page 125

• Manufacturer Part Number: EP3C5F256C8N
• Description: IC CYCLONE III FPGA 5K 256-FBGA
• Manufacturer: Altera
• Series: Cyclone® IIIr

Specifications of EP3C5F256C8N

• Number Of Logic Elements/cells: 5136
• Number Of Labs/clbs: 321
• Total Ram Bits: 423936
• Number Of I /o: 182
• Voltage - Supply: 1.15 V ~ 1.25 V
• Mounting Type: Surface Mount
• Operating Temperature: 0°C ~ 85°C
• Package / Case: 256-FBGA
• No. Of Logic Blocks: 321
• Family Type: Cyclone III
• No. Of I/o's: 182
• I/o Supply Voltage: 3.3V
• Operating Frequency Max: 402MHz
• Operating Temperature Range: 0°C To +85°C
• Rohs Compliant: Yes
• For Use With: 544-2601 - KIT DEV CYCLONE III LS EP3CLS200544-2411 - KIT DEV NIOS II CYCLONE III ED.
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Number Of Gates: -
• Other names: 544-2423; EP3C5F256C8N

High-Speed I/O Interface
© December 2009
CIII51008-3.2
f
Altera Corporation
This chapter describes the high-speed differential I/O features and resources in the
Cyclone III device family.
High-speed differential I/O standards have become popular in high-speed interfaces
because of their significant advantages over single-ended I/O standards. The Altera
Cyclone
BLVDS, reduced swing differential signaling (RSDS), mini-LVDS, and point-to-point
differential signaling (PPDS).
This chapter contains the following sections:
■
■
■
■
■
■
Cyclone III device family I/Os are separated into eight I/O banks, as shown in
Figure
LVDS, RSDS, mini-LVDS, and PPDS are on the left and right I/O banks. These I/O
standards are also supported on the top and bottom I/O banks using external
resistors. On the left and right I/O banks, some of the differential pin pairs (p and n
pins) of the true output drivers are not located on adjacent pins. In these cases, a
power pin is located between the p and n pins. These I/O standards are also
supported on all I/O banks using two single-ended output with the second output
programmed as inverted, and an external resistor network. True input buffers for
these I/O standards are supported on all I/O banks.
For more information about the location of Cyclone III device family true differential
pins, refer to the
“High-Speed I/O Interface” on page 7–1
“High-Speed I/O Standards Support” on page 7–7
“True Output Buffer Feature” on page 7–15
“High-Speed I/O Timing” on page 7–16
“Design Guidelines” on page 7–17
“Software Overview” on page 7–18
7–1. Each bank has an independent power supply. True output drivers for
®
III device family (Cyclone III and Cyclone III LS devices) supports LVDS,
Cyclone III Devices Pin-Outs
7. High-Speed Differential Interfaces in
the Cyclone III Device Family
on the Altera website.
Cyclone III Device Handbook, Volume 1
®