ELLXT971ABE.A4 Intel, ELLXT971ABE.A4 Datasheet - Page 20

• Manufacturer Part Number: ELLXT971ABE.A4
• Description: IC TRANS 3.3V ETHERNET 64-BGA
• Manufacturer: Intel
• Type: PHY Transceiverr

Specifications of ELLXT971ABE.A4

• Number Of Drivers/receivers: 1/1
• Protocol: IEEE 802
• Voltage - Supply: 3.14 V ~ 3.45 V
• Mounting Type: Surface Mount
• Package / Case: 64-BGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 870479

Intel
20
Table 6.
Table 7.
®
LXT971A Single-Port 10/100 Mbps PHY Transceiver
Table 6
Intel
Table 7
Intel
PBGA
Pin#
PBGA
G1
F1
F2
E2
E1
Pin#
H2
H3
H4
H5
G2
®
®
LXT971A Transceiver Network Interface Signal Descriptions
LXT971A Transceiver Standard Bus and Interface Signal Descriptions
lists signal descriptions of the LXT971A Transceiver network interface pins.
lists signal descriptions of the LXT971A Transceiver standard bus and interface signals.
LQFP
Pin#
16
15
14
13
12
LQFP
Pin#
19
20
23
24
26
Symbol
ADDR0
TPFOP
TPFON
TPFIP
TPFIN
SD/TP_L
Symbol
Type
I
I
I
I
I
Type
O
I
I
Address.
Sets device address.
Twisted-Pair/Fiber Outputs, Positive and Negative.
During 100BASE-TX or 10BASE-T operation, TPFOP/N pins drive
IEEE 802.3 compliant pulses onto the line.
During 100BASE-FX operation, TPFOP/N pins produce differential
LVPECL outputs for fiber transceivers.
Twisted-Pair/Fiber Inputs, Positive and Negative.
During 100BASE-TX or 10BASE-T operation, TPFIP/N pins receive
differential 100BASE-TX or 10BASE-T signals from the line.
During 100BASE-FX operation, TPFIP/N pins receive differential
LVPECL inputs from fiber transceivers.
Signal Detect / Twisted Pair.
SD/TP_L acts as a dual-function input, depending on the LXT971A
Transceiver mode.
Normal, Reset, and Power-Up Operations.
“Normal” operation is operation other than reset or power-up. In
either reset or power-up, SD/TP_L is used to select one of the two
following media modes.
Twisted-Pair Mode.
For normal operation that uses the twisted-pair mode, connect SD/
TP_L to ground.
Fiber Mode.
For normal operation that uses the fiber mode, SD/TP_L acts as the
SD input from the fiber transceiver.
• Twisted-pair mode - Connect SD/TP_L Low
• Fiber mode - Connect SD/TP_L High (Register bit 16.0 = 1).
(Register bit 16.0 = 0).
Signal Description
Signal Description
Document Number: 249414-003
Revision Date: June 18, 2004
Datasheet