5384 3M Interconnect Solutions, 5384 Datasheet - Page 15

• Manufacturer Part Number: 5384
• Manufacturer: 3M Interconnect Solutions

Specifications of 5384

• Lead Free Status / Rohs Status: Supplier Unconfirmed

D. Install Lug Cover
1.
2.
3.
Note: The kit contains a small tube of Silicone Grease. Use it to lightly lubricate the mastic and vinyl tape wraps. This
4.
Hint: Inserting the cable tie from the back side of the Lug Cover will aid in visually aligning the cable tie through both holes.
5.
Figure 31
Figure 32
30014 through 30045
One hole
78-8126-9102-6-B
will aid in the installation of the Lug Cover.
Separate cables and apply mastic strip between and around them,
(Figure 31). Mastic will be on end of termination and cold shrink jacketing tube. Build mastic to an overall
diameter that is greater than the inside diameter of the Lug Cover. Press cables together and make certain that no
void exists between them (Figure 31).
Overwrap the mastic with 1 or 2 wraps of vinyl tape (Figure 31).
Install Lug Cover. Position Lug Cover so the punched holes are positioned between the cables (Figure
32).
Be sure that the punched holes are beyond the cable end of the mastic and vinyl tape wrap. Insert the cable tie
through the holes (Figure 32).
Tighten the cable tie. Cut off excess length only if necessary. Cable ties are reusable
������ ������ ���� ���� ������
��������� ���� � �����������
Lug and Crimping Information for 3M
������ �����
��������
Tooling Index
����� ���
������ ���
����� ���� ����
15
31145 through 31166
Two hole
™
Scotchlok
centered over jacketing tube and termination
™
Copper Lugs
.