5384 3M Interconnect Solutions, 5384 Datasheet - Page 3

• Manufacturer Part Number: 5384
• Manufacturer: 3M Interconnect Solutions

Specifications of 5384

• Lead Free Status / Rohs Status: Supplier Unconfirmed

3. Install Lug Cover. Position Lug Cover so the punched holes are positioned between the cables (Figure 3).
Note: The kit contains a small tube of Silicone Grease. Use it to lightly lubricate the mastic and vinyl tape wraps.
3.1 Be sure that the punched holes are beyond the cable end of the mastic and vinyl tape wrap. Insert the cable
Hint: Inserting the cable tie from the back side of the Lug Cover will aid in visually aligning the cable tie through
both holes.
3.2 Tighten the cable tie. Cut off excess length only if necessary. Cable ties are reusable.
A.
1.
For Non-Shielded Motor Lead Cable
2.
3.
Figure 3
78-8126-9102-6-B
tie through the holes (Figure 3).
This will aid in the installation of the Lug Cover.
Prepare Cable According to Standard Procedures
Check to be sure cables sizes fit within cable kit range as shown in Table 1 on cover.
Remove cable insulation for length recommended by terminal lug manufacturer; if no information is
available, remove for depth of lug barrel.
Clean insulation for approximately 6" (150 mm) using solvent-saturated cloth provided in kit.
Instructions for 5/8 kV Shielded Feeder Cables
(Tape, Wire Shielded or UniShield
for Non-Grounded Applications
����� ���
3
®
Cables)