5384 3M Interconnect Solutions, 5384 Datasheet - Page 4

Manufacturer Part Number

5384

Description

Manufacturer

3M Interconnect Solutions

Datasheet

1.5384.pdf (16 pages)

Lead Free Status / Rohs Status

Supplier Unconfirmed

For Shielded Motor Lead Cable (if connection is to be grounded, see next section)

For Tape Shielded Cable see Figures 4a and 5a.

For Wire Shielded Cable see Figures 4b and 5b.

For UniShield® Cable see Figures 4c and 5c.

Figure 4a

for Tape Shielded Cable

Figure 4c

for UniShield® Cable

Figure 4b

for Wire Shielded Cable

Note: To ease jacket removal, install constant force spring as shown in Figure 23 and ring cut 80% through jacket.

Prepare cable by removing jacket and shielding per dimensions as shown in Figure 4, depending on type

of cable shielding. Apply copper tape strip over tape or wire shield to secure. See Figure 4a, 4b and 4c,

depending on type of cable shielding.

Remove cable insulation for length recommended by terminal lug manufacturer; if no information is

available, remove for depth of lug barrel.

Clean cable insulation by using solvent-saturated cloths. Do not allow solvent to touch cable semi-con.

If abrasive must be used to remove imbedded semi-con from cable insulation, use a non-conductive, 120-

grit aluminum oxide, such as in the 3M

Remove jacket section by pulling against constant force spring. DO NOT BELL SEMI-CON JACKET.

Remove constant force spring.

Some UniShield

cable preparation.

��

cables feature dual-layer semi-conductive jackets. Both layers must be removed during

��

™

Cable Prep Kit CC-2 or 3M Abrasive Roll A-3.

��

� ��

��

78-8126-9102-6-B