5384 3M Interconnect Solutions, 5384 Datasheet - Page 6

• Manufacturer Part Number: 5384
• Manufacturer: 3M Interconnect Solutions

Specifications of 5384

• Lead Free Status / Rohs Status: Supplier Unconfirmed

C.
1.
2.
D.
1.
2.
3.
Note: The kit contains a small tube of Silicone Grease. Use it to lightly lubricate the mastic and vinyl tape wraps. This
will aid in the installation of the Lug Cover.
4.
Hint: Inserting the cable tie from the back side of the lug cover will aid in visually aligning the cable tie through both
holes.
5.
Figure 6
Figure 7
Figure 8
Install Lugs
Install and crimp lugs per manufacturer's direction; see back page if 3M
Bolt lugs together. See Table 1 on cover for maximum bolt length. See Figure 6 for proper bolt/lug
arrangement.
Install Lug Cover
Separate cables and apply mastic strip between and around them, centered over cable jacket and
termination (Figure 7). Mastic will be on end of termination and cable jacket. Build mastic to an overall
diameter that is greater than the inside diameter of the lug cover. Press cables together and make certain
that no void exists between them (Figure 7).
Overwrap the mastic with 1 or 2 wraps of vinyl tape (Figure 7).
Install lug cover. Position lug cover so the punched holes are positioned between the cables (Figure 8)
Be sure that the punched holes are beyond the cable end of the mastic and vinyl tape wrap. Insert the
cable tie through the holes (Figure 8).
Tighten the cable tie. Cut off excess length only if necessary. Cable ties are reusable.
������ ������ ���� ���� ������
��������� ���� � �����������
����� ���
������ ���
����� ���� ����
6
™
Lugs are used.
����� ���
����� ���
������
78-8126-9102-6-B