AT32UC3C1128C Atmel Corporation, AT32UC3C1128C Datasheet - Page 613

• Manufacturer Part Number: AT32UC3C1128C
• Manufacturer: Atmel Corporation

Specifications of AT32UC3C1128C

• Flash (kbytes): 128 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 66 MHz
• Cpu: 32-bit AVR
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 81
• Ext Interrupts: 100
• Usb Transceiver: 1
• Quadrature Decoder Channels: 2
• Usb Speed: Full Speed
• Usb Interface: Device + OTG
• Spi: 7
• Twi (i2c): 3
• Uart: 5
• Can: 2
• Lin: 5
• Ssc: 1
• Ethernet: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 16
• Adc Resolution (bits): 12
• Adc Speed (ksps): 2000
• Analog Comparators: 4
• Resistive Touch Screen: No
• Dac Channels: 4
• Dac Resolution (bits): 12
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 36
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0 to 3.6 or 4.5 to 5.5
• Operating Voltage (vcc): 3.0 to 3.6 or 4.5 to 5.5
• Fpu: Yes
• Mpu / Mmu: Yes / No
• Timers: 6
• Output Compare Channels: 22
• Input Capture Channels: 12
• Pwm Channels: 19
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

25.6.11
25.6.11.1
32117C–AVR-08/11
LIN Frame Handling
Master Node Configuration
What comes next depends on the NACT configuration:
• Write TXEN and RXEN in CR to enable both the transmitter and the receiver.
• Write MODE in MR to select the LIN mode and the Master Node configuration.
• Write CD and FP in BRGR to configure the baud rate.
• Write NACT, PARDIS, CHKDIS, CHKTYPE, DLCM, FSDIS and DLC in LINMR to configure
• Check that TXRDY in CSR is set to “1”
• Write IDCHR in LINIR to send the header
• Case 1: NACT = PUBLISH, the USART sends the response
• Case 2: NACT = SUBSCRIBE, the USART receives the response
• Case 3: NACT = IGNORE, the USART is not concerned by the response
the frame transfer.
– Wait until TXRDY in CSR rises
– Write TCHR in THR to send a byte
– If all the data have not been written, redo the two previous steps
– Wait until LINTC in CSR rises
– Check the LIN errors
– Wait until RXRDY in CSR rises
– Read RCHR in RHR
– If all the data have not been read, redo the two previous steps
– Wait until LINTC in CSR rises
– Check the LIN errors
– Wait until LINTC in CSR rises
– Check the LIN errors
AT32UC3C
613