SAM9G20 Atmel Corporation, SAM9G20 Datasheet - Page 184

• Manufacturer Part Number: SAM9G20
• Manufacturer: Atmel Corporation

Specifications of SAM9G20

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 400 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 7
• Ssc: 1
• Ethernet: 1
• Sd / Emmc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: Yes
• Adc Channels: 4
• Adc Resolution (bits): 10
• Adc Speed (ksps): 95
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 0.9 to 1.1
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

22. Power Management Controller (PMC)
22.1
22.2
184
Description
Embedded Characteristics
SAM9G35
The Power Management Controller (PMC) optimizes power consumption by controlling all sys-
tem and user peripheral clocks. The PMC enables/disables the clock inputs to many of the
peripherals and the Core.
The Power Management Controller provides all the clock signals to the system.
PMC input clocks:
PMC output clocks:
Note:
This allows software control of five flexible operating modes:
• UPLLCK : From UTMI PLL
• PLLACK : From PLLA
• SLCK: slow clock from external 32 kHz oscillator or internal 32 kHz RC oscillator
• MAINCK: Main Clock from external 12 MHz oscillator or internal 12 MHz RC Oscillator
• Processor Clock PCK.
• Master Clock MCK, in particular to the Matrix, the memory interfaces, the peripheral bridge.
• Each peripheral embeds its own divider, programmable in the PMC User Interface.
• 133MHz DDR clock
• LCD pixel clock that can use DDR clock or MCK, the choice is done in the LCD user
• USB Host EHCI High speed clock (UPLLCK)
• USB OHCI clocks (UHP48M and UHP12M)
• Two programmable clock outputs: PCK0 and PCK1
• SMD clock
• Normal Mode, processor and peripherals running at a programmable frequency
• Idle Mode, processor stopped waiting for an interrupt
• Slow Clock Mode, processor and peripherals running at low frequency
• Standby Mode, mix of Idle and Backup Mode, peripheral running at low frequency, processor
• Backup Mode, Main Power Supplies off, VDDBU powered by a battery
The divider can be 2, 3 or 4.
interface.
stopped waiting for an interrupt
DDR clock is not available when Master Clock (MCK) equals Processor Clock (PCK).
11053B–ATARM–22-Sep-11