ST7FOXK1 STMicroelectronics, ST7FOXK1 Datasheet - Page 102

• Manufacturer Part Number: ST7FOXK1
• Description: Low cost flash 8bit micro
• Manufacturer: STMicroelectronics

Specifications of ST7FOXK1

• 4 To 8 Kbytes Single Voltage Extended Flash (xflash) Program Memory With Read-out Protection In-circuit Programming And In-application Programming (icp And Iap) Endurance: 1K write/erase cycles guaranteed Data retention
• Clock Sources: Internal trimmable 8 MHz RC oscillator, auto wakeup internal low power - low frequency oscillator, crystal/ceramic resonator or external clock
• Five Power Saving Modes: Halt, Active-Halt, Auto Wakeup from Halt, Wait and Slow
• A/d Converter: up to 10 input channels

On-chip peripherals
102/226
Bit 5 = BA1 Break 1 Active bit (BA on ST7FOXF1/ST7FOXK1)
Bit 4 = BP1EN Break 1Pin Enable bit (BPEN on ST7FOXF1/ST7FOXK1)
Bits 3:0 = PWM[3:0] Break Pattern bits
This bit is read/write by software, cleared by hardware after reset and set by hardware
when the active level defined by the BR1EDGE bit is applied on the BREAK1 pin. It
activates/deactivates the Break 1function.
0: Break 1not active
1: Break 1active
This bit is read/write by software and cleared by hardware after Reset.
0: Break 1pin disabled
1: Break 1pin enabled
These bits are read/write by software and cleared by hardware after a reset. They are
used to force the four PWMx output signals into a stable state when the Break function
is active and corresponding OEx bit is set.
ST7FOXF1, ST7FOXK1, ST7FOXK2