ST7FOXK1 STMicroelectronics, ST7FOXK1 Datasheet - Page 87

• Manufacturer Part Number: ST7FOXK1
• Description: Low cost flash 8bit micro
• Manufacturer: STMicroelectronics

Specifications of ST7FOXK1

• 4 To 8 Kbytes Single Voltage Extended Flash (xflash) Program Memory With Read-out Protection In-circuit Programming And In-application Programming (icp And Iap) Endurance: 1K write/erase cycles guaranteed Data retention
• Clock Sources: Internal trimmable 8 MHz RC oscillator, auto wakeup internal low power - low frequency oscillator, crystal/ceramic resonator or external clock
• Five Power Saving Modes: Halt, Active-Halt, Auto Wakeup from Halt, Wait and Slow
• A/d Converter: up to 10 input channels

ST7FOXF1, ST7FOXK1, ST7FOXK2
Figure 40. Dead time generation
In the above example, when the DTE bit is set:
With this programmable delay (Tdt), the PWM0 and PWM1 signals which are generated are
not overlapped.
Break function
The break function can be used to perform an emergency shutdown of the application being
driven by the PWM signals.
The break function is activated by the external BREAK pin. This can be selected by using
the BRSEL bit in BREAKCR register. In order to use the break function it must be previously
enabled by software setting the BPEN bit in the BREAKCR register.
The Break active level can be programmed by the BREDGE bit in the BREAKCR register.
When an active level is detected on the BREAK pin, the BA bit is set and the break function
is activated. In this case, the PWM signals are forced to BREAK value if respective OEx bit
is set in PWMCR register.
Software can set the BA bit to activate the break function without using the BREAK pin. The
BREN1 and BREN2 bits in the BREAKEN register are used to enable the break activation
on the 2 counters respectively. In Dual Timer mode, the break for PWM2 and PWM3 is
enabled by the BREN2 bit. In Single Timer mode, the BREN1 bit enables the break for all
PWM channels.
CK_CNTR1
CNTR1
PWM goes low at DCR0 match and goes high at ATR1+Tdt
PWM1 goes high at DCR0+Tdt and goes low at ATR match.
PWM 1
PWM 0
PWM 0
PWM 1
counter = DCR0
DCR0
DCR0+1
T
counter1
T
dt
counter = DCR1
OVF
T
dt
= DT[6:0] x T
ATR1
counter1
T
dt
On-chip peripherals
87/226